Abstract
The research presented here seeks to address the key parameters influential on out-of-plane (OOP) instability of rectangular walls, which was observed in the 2010 Chile and the 2011 New Zealand earthquakes in some well-confined modern walls. For this purpose, a finite element model, previously verified for its capability to reliably simulate different failure modes of this type of structural walls, was adopted. The parametric matrix included a series of specimens designed to be tested by the authors and other specimens already tested by other researchers. The effect of slenderness (unsupported height-to-thickness) ratio, reinforcement ratio, length and axial load on the OOP response of these specimens is scrutinized using the predicted response of the boundary region longitudinal reinforcement at the elevation corresponding to the maximum OOP displacement in each case. For a given slenderness and longitudinal reinforcement ratio, development of a critical average tensile strain over a certain height can lead to formation of OOP instability in walls. Therefore, the effect of these parameters on the strain history, strain gradient along the wall height, as well as the stress–strain response of the longitudinal bars throughout the cyclic loading are evaluated and the variation of the OOP response attributable to the effect of each parameter is discussed. This parametric study indicated that the initiation of OOP displacement in doubly reinforced walls after unloading from a peak displacement and during reloading in the opposite direction is in line with the significant reduction of compressive stiffness (yielding in compression) in the boundary region longitudinal bars along a specific height (at least 60% of the wall height). Based on the findings of this study, an experimental campaign was designed and four of the parametric models were experimentally tested under in-plane cyclic loading. In addition to the parameters noted above, the effects of shear strength, boundary conditions and eccentricity of material properties across the wall thickness on the OOP response of the benchmark parametric model are also briefly discussed. The experimental observations as well as the numerical versus experimental comparisons are presented in a companion paper.
Similar content being viewed by others
References
Birely AC (2013) Seismic performance of slender reinforced concrete structural walls. PhD 983, University of Washington
Bosco M, Ferrara E, Ghersi A, Marino EM, Rossi PP (2016) Improvement of the model proposed by Menegotto and Pinto for steel. Eng Struct 124:442–456. https://doi.org/10.1016/j.engstruct.2016.06.037
CERC (2012) Canterbury earthquakes royal commission reports. https://canterbury.royalcommission.govt.nz/Final-Report-Volume-Two-Contents
Chai YH, Elayer DT (1999) Lateral stability of reinforced concrete columns under axial reversed cyclic tension and compression. ACI Struct J 96(5):780–789
Dashti F (2017) Out-of-plane instability of rectangular reinforced concrete walls under in-plane loading. PhD Thesis, 294, Department of Civil and Natural Resources Engineering, University of Canterbury
Dashti F, Dhakal RP, Pampanin S (2014) Simulation of out-of-plane instability in rectangular RC structural walls. In: Second European conference on earthquake engineering and seismology, Istanbul, Turkey
Dashti F, Dhakal RP, Pampanin S (2015) Development of out-of-plane instability in rectangular RC structural walls 2015 NZSEE Conference, Rotorua, New Zealand, New Zealand Society for Earthquake Engineering
Dashti F, Dhakal RP, Pampanin S (2017a) Numerical modeling of rectangular reinforced concrete structural walls. J Struct Eng 143(6):04017031
Dashti F, Dhakal RP, Pampanin S (2017b) Tests on slender ductile structural walls designed according to New Zealand standard. Bull NZ Soc Earthq Eng 50(4):504–516
Dashti F, Dhakal RP, Pampanin S (2018a) Validation of a numerical model for prediction of out-of-plane instability in ductile structural walls under concentric in-plane cyclic loading. J Struct Eng 144(6):04018039
Dashti F, Dhakal RP, Pampanin S (2018b) Blind prediction of in-plane and out-of-plane responses for a thin singly reinforced concrete flanged wall specimen. Bull Earthq Eng 16(1):427–458. https://doi.org/10.1007/s10518-017-0211-x
Dashti F, Dhakal RP, Pampanin S (2018c) Evolution of out-of-plane deformation and subsequent instability in rectangular RC walls under in-plane cyclic loading: experimental observation. Earthq Eng Struct Dyn 47(15):2944–2964
Dashti F, Dhakal RP, Pampanin S (2018d) Inelastic strain gradients in reinforced concrete structural walls. In: 16th European conference on earthquake engineering. Thessaloniki, Greece
Dashti F, Dhakal RP, Pampanin S (2019) A parametric investigation on applicability of the curved shell finite element model to nonlinear response prediction of planar RC walls. Bull Earthq Eng 17:6515–6546. https://doi.org/10.1007/s10518-019-00582-8
Dashti F, Dhakal RP, Pampanin S (2020) A parametric study on out-of-plane instability of doubly reinforced structural walls. Part II: experimental investigation. Bull Earthq Eng (in press)
Filippou FC, Popov EP, Bertero VV (1983) Effects of bond deterioration on hysteretic behavior of reinforced concrete joints. Report EERC No. 83-19
Haro AG, Kowalsky M, Chai YH, Lucier GW (2018) Boundary elements of special reinforced concrete walls tested under different loading paths. Earthq Spectra 34(3):1267-1288. https://doi.org/10.1193/081617eqs160m
Johnson B (2010) Anchorage detailing effects on lateral deformation components of R/C shear walls. Master Thesis, University of Minnesota
Kolozvari K, Biscombe L, Dashti F, Dhakal RP, Gogus A, Gullu F, Henry R, Massone L, Orakcal K, Rojas F, Shegay A, Wallace J (2019) State-of-the-art in nonlinear finite element modeling of isolated planar reinforced concrete walls. Eng Struct 194:46–65. https://doi.org/10.1016/j.engstruct.2019.04.097
Menegotto M, Pinto P (1973) Method of analysis for cyclically loaded reinforced concrete plane frames including changes in geometry and non-elastic behavior of elements under combined normal force and bending. IABSE Symposium on the Resistance and Ultimate Deformability of Structures Acted on by Well-Defined Repeated Loads, Lisbon, Association internationale des ponts et charpentes
NZS 3101:2006 (2008) Concrete structures standard part 1 - the design of concrete structures (Amendment No. 2). Standards New Zealand, Wellington, New Zealand
NZS 3101:2006 (2017) Concrete structures standard part 1 - the design of concrete structures (Amendment No. 3). Standards New Zealand, Wellington, New Zealand
Oesterle R, Fiorato A, Johal L, Carpenter J, Russell H, Corley W (1976) Earthquake resistant structural walls: tests of isolated walls. Research and Development Construction Technology Laboratories, Portland Cement Association, New York
Paulay T, Goodsir W (1985) The ductility of structural walls. Bull NZ Soc Earthq Eng 18(3):250–269
Paulay T, Priestley M (1993) Stability of ductile structural walls. ACI Struct J 90(4):385–392
Rosso A, Almeida J, Beyer K (2016) Stability of thin reinforced concrete walls under cyclic loads: state-of-the-art and new experimental findings. Bull Earthq Eng 14:455–484. https://doi.org/10.1007/s10518-015-9827-x
Rosso A, Jiménez-Roa LA, de Almeida JP, Zuniga APG, Blandón CA, Bonett RL, Beyer K (2017) Cyclic tensile-compressive tests on thin concrete boundary elements with a single layer of reinforcement prone to out-of-plane instability. Bull Earthq Eng. https://doi.org/10.1007/s10518-017-0228-1
Rosso A, Jiménez-Roa LA, de Almeida JP, Beyer K (2018) Out-of-plane instability of thin single-layered members: advancements in the characterization of the mechanism. In: 16th European conference on earthquake engineering. Thessaloniki, Greece
Thomsen IV JH, Wallace JW (1995) Displacement-based design of reinforced concrete structural walls: an experimental investigation of walls with rectangular and T-shaped cross-sections. Report No. CU/CEE-95-06, Department of Civil and Environmental Engineering, Clarkson University, Potsdam, NY
Tripathi M, Dhakal RP, Dashti F, Gokhale R (2020a) Axial response of rectangular RC prisms representing the boundary elements of ductile concrete walls. Bull Earthq Eng (in press)
Tripathi M, Dhakal RP, Dashti F (2020b) Nonlinear cyclic behaviour of high-strength ductile RC walls: experimental and numerical investigations. Eng Struct (in press)
Acknowledgements
The authors wish to acknowledge the financial support provided by the Natural Hazard Research Platform (NHRP), the Ministry of Business, Innovation and Employment (MBIE) and the Quake Centre at the University of Canterbury to conduct this research.
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Dashti, F., Dhakal, R.P. & Pampanin, S. A parametric study on out-of-plane instability of doubly reinforced structural walls. Part I: FEM predictions. Bull Earthquake Eng 18, 3747–3780 (2020). https://doi.org/10.1007/s10518-020-00828-w
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10518-020-00828-w