Abstract
A series of small and large-scale tests were performed to measure the radiant transmission of energy and the window breakage characteristics of seven different multi-plane glazing samples. The samples tested included both double and triple-pane glazing specimens with a laminate interlayer between panes for additional strength. These test series were designed to provide the information necessary to assess the hazard from radiant energy to building occupants and contents due to a large fire in close proximity to a structure with a large amount of exterior windows. For incident heat fluxes 30 kW/m2 or lower, the triple-pane glazing samples had a total transmittance less than 10% of the incident heat flux, back-side surface temperatures did not exceed 100°C, and the back-side heat flux did not exceed 4 kW/m2. For double-pane laminates, the total transmittance was less than 25% of the incident heat flux, the back-side temperature did not exceed 220°C, and the back-side heat flux did not exceed 5 kW/m2. For incident heat fluxes greater than 30 kW/m2, the glazing samples degraded very quickly, generally buckling and losing integrity. The time for the first pane to crack decreased with increasing incident flux level. A number of tests included a water deluge system, which served to maintain sample integrity for extended exposures. In these cases, the total transmittance was less than 6% of the incident heat flux, back-side surface temperatures did not exceed 45°C, and the back-side heat flux did not exceed 1 kW/m2.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
NFPA 415, “Standard on Airport Terminal Buildings, Fueling Ramp Drainage, and Loading Walkways,” National Fire Protection Association, Quincy, MA, 2002.
H.W. Emmons, “The Needed Fire Science,” in Fire Safety Science—Proceedings of the Fire International Symposium, C.E. Grant and P.J. Pagni (eds.) Hemisphere, Washington, D.C., 1986, pp. 33–53.
P.K. Barth and H. Sung, “Glass Fracture under Intense Heating,” Senior Project, Harvard University, Cambridge, MA, 1977.
P.J. Pagni, “Fire Physics—Promises, Problems, and Progress,” in Fire Safety Science—Proceedings of the Second International Symposium, C.E. Grant and P.J. Pagni (eds.) Hemisphere, Washington, D.C., 1988, pp. 49–66.
P.J. Pagni and A.A. Joshi, “Glass Breaking in Fires,” in Fire Safety Science—Proceedings of the Third International Symposium, G. Cox and B. Longford (eds.) Hemisphere, Washington, D.C., 1991, pp. 791–802.
A.A. Joshi and P.J. Pagni, “Fire-Induced Thermal Fields in Window Glass. I—Theory,” Fire Safety Journal, 22(1), 1994, pp. 25–43.
A.A. Joshi and P.J. Pagni, “Fire-Induced Thermal Fields in Window Glass. II— Experiments,” Fire Safety Journal, vol. 22, no. 1, 1994, pp. 45–65.
O. Keski-Rahkomen, “Breaking of Window Glass Close to Fire,” Fire and Materials, vol. 12, 1988, pp. 61–69.
O. Keski-Rahkomen, “Breaking of Window Glass Close to Fire, II: Circular Panes,” Fire and Materials, vol. 15, 1991, pp. 11–16.
M.J. Skelly, R.J. Roby, and C.L. Beyler, “An Experimental Investigation of Glass Breakage in Compartment Fires,” Journal of Fire Protection Engineering, vol. 3, no. 1, 1991, pp. 24–34.
G.W. Silcock and Shields, “An Experimental Evaluation of Glazing in Compartment Fires,” Interflam, vol. 93, 1993, pp. 747–756.
T.J. Shields, G.W.H. Silcock, and F. Flood, “Performance of a Single Glazing Assembly Exposed to Enclosure Corner Fires of Increasing Severity,” Fire and Materials, vol. 25, 2001, pp. 123–152.
F.W. Mowrer, “Window Breakage Induced by Exterior Fires,” National Institutes of Standards and Technology, NIST-GCR-98-751, 1998.
J.D. Cohen and P. Wilson, “Current Results from Structure Ignition Assessment Model (SIAM) Research,” Fire Management in the Wildland/Urban Interface: Sharing Solutions, Alberta, Canada, 1994.
N.A. McArthur, “The Performance of Aluminum Building Products in Bushfires,” Fire and Materials, vol. 15, 1991, pp. 117–125.
K. Harada, A. Enomoto, K. Uede, and T. Wakamatsu, “Experimental Study on Glass Cracking and Fallout by Radiant Heat Exposure,” in Fire Safety Science—Proceedings of the Sixth International Symposium, M. Curtat (eds.) IAFSS, 2000, pp. 1063–1074.
B.R. Cuzillo and P.J. Pagni, “Thermal Breakage of Double-Pane Glazing by Fire,” Journal of Fire Protection Engineering, vol. 9, 1998, pp. 1–11.
G.S. Cowles, “The Attenuation of Radiation from Building Fires through Fire-resistant Glazing,” Fire Safety Science—Proceedings of the Fifth International Symposium, 1997, p. 1357.
ASTM E 1321-97a, “Standard Test Method for Determining Material Ignition and Flame Spread Properties,” American Society for Testing and Materials, Philadelphia, PA, 1997.
R. Siegel and J.R. Howell, Thermal Radiation Heat Transfer, (2nd edition), Hemisphere Publishing Corporation, New York, 1982, pp. 727–730.
D.A. Purser, “Toxicity Assessment of Combustion Products,” The SFPE Handbook of Fire Protection Engineering, 2nd edition, 1995.
K. Mudan and P. Croce, “Fire Hazard Calculations for Large Open Hydrocarbon Fires,” The SFPE Handbook of Fire Protection Engineering, 2nd edition, 1995.
P.H. Thomas, “The Size of Flames from Natural Fires,” in 9thInternational Combustion Symposium, Combustion Institute, Pittsburgh, PA, pp. 844–859, 1963.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Klassen, M.S., Sutula, J.A., Holton, M.M. et al. Transmission Through and Breakage of Multi-Pane Glazing Due to Radiant Exposure. Fire Technol 42, 79–107 (2006). https://doi.org/10.1007/s10694-006-7254-x
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10694-006-7254-x