Abstract
Auger mining (AM) is an effective and safe way to excavate an extremely thin protective layer. This method can relieve pressure and enhance the permeability of an ultra-contiguous coal layer with high gas capacity. However, there have been few studies on AM. Based on the conditions of a coal mine in Shanxi Province, China, theoretical analyses, laboratory tests and numerical simulations were used to analyze the evolution law of the overburden permeability in an AM face. A stress–damage–permeability coupling model was proposed, and a numerical simulation algorithm for fluid–solid coupling with FLAC software was established. Through this method, the evolution law of stress and permeability and its influencing factors of the overburden of the AM face were found. The intermediate coal pillar (ICP) width and the AM height and length are the main factors influencing the permeability evolution of the AM face. The first factor determines the damage state of the ICP in the goaf, and the last two factors influence the zone size with permeability enhancement of the protected layer. Therefore, reasonable AM parameter design is the key to both safe mining operations in the AM face and pressure relief and permeability enhancement.
Similar content being viewed by others
References
Chen, H. D., Yuan, P. C., Zhou, H. X., & Li, W. (2013). Damage and permeability development in coal during unloading. Rock Mechanics and Rock Engineering,46(6), 1377–1390. https://doi.org/10.1007/s00603-013-0370-2.
Cheng, Y. P., Wang, L., & Zhang, X. L. (2011). Environmental impact of coal mine methane emissions and responding strategies in China. International Journal of Greenhouse Gas Control,5(1), 157–166. https://doi.org/10.1016/j.ijggc.2010.07.007.
Durucan, S. (1981). An investigation into the stress-permeability relationship of coals and flow patterns around working longwall faces. Nottingham: University of Nottingham.
Guo, W. (2007). Application on technology of auger mining in Tunlan coal mine. Shanxi Coking Coal Science and Technology,9, 14–15. https://doi.org/10.3969/j.issn.1672-0652.2007.09.005.
Jiang, Z. Q., Ji, L. J., Zuo, R. S., & Cao, L. W. (2002). Correlativity among rock permeability and strain, stress under servo-control condition. Chinese Journal of Rock Mechanics and Engineering,10, 002. https://doi.org/10.3321/j.issn:1000-6915.2002.10.002.
Li, J. P., Du, C. L., & Zhang, Y. Z. (2005). Present status and development tendency of mining equipment for thin and ultra thin seam in China. Coal Science and Technology,33, 65–67. https://doi.org/10.3969/j.issn.0253-2336.2005.06.023.
Liu, H. B., Cheng, Y. P., Song, J. C., Shang, Z. J., & Wang, L. (2009a). Pressure relief, gas drainage and deformation effects on an overlying coal seam induced by drilling an extra-thin protective coal seam. Mining Science and Technology,19(6), 724–729. https://doi.org/10.1016/s1674-5264(09)60132-0.
Liu, L., Cheng, Y. P., Wang, H. F., Wang, L., & Ma, X. Q. (2009b). Principle and engineering application of pressure relief gas drainage in low permeability outburst coal seam. Mining Science and Technology,19(3), 342–345. https://doi.org/10.1016/S1674-5264(09)60064-8.
Liu, Y. K., Zhou, F. B., Liu, L., Liu, C., & Hu, S. Y. (2011). An experimental and numerical investigation on the deformation of overlying coal seams above double-seam extraction for controlling coal mine methane emissions. International Journal of Coal Geology,87(2), 139–149. https://doi.org/10.1016/j.coal.2011.06.003.
Meng, P., Ye, J. Y., Wang, Z. F., & Shang, Z. J. (2011). Numerical analysis of overlying rocks changes by drilling extra-thin coal seam. Coal Technology, 11, 72–74.
Ping, L. U., Sheng, Z. W., & Zhu, G. W. (2002). Characterization of and experimental study on the permeability of rock-samples during complete stress-strain course. Journal-University of Science and Technology of China,32(6), 678–684. https://doi.org/10.3969/j.issn.0253-2778.2002.06.008.
Ren, T. X., & Edwards, J. S. (2002). Goaf gas modeling techniques to maximize methane capture from surface gob wells. In E. De Souza (Ed.), Mine ventilation (pp. 279–286). Balkema.
State Administration of Work Safety. (2016). Coal mine safety regulations. Beijing: Coal Industry Press.
Wang, F. T., Zhang, C., & Liang, N. N. (2017b). Gas permeability evolution mechanism and comprehensive gas drainage technology for thin coal seam mining. Energies,10(9), 1382. https://doi.org/10.3390/en10091382.
Wang, H. F., Zhong, S. J., Cheng, Y. P., & Wei, G. G. (2013). Theoretical thickness of protective layer mining and its application on pressure relief gas drainage. Electronic Journal of Geotechnical Engineering,18, 765–774.
Wang, L., Liu, S. M., Cheng, Y. P., Yin, G. Z., Zhang, D. M., & Guo, P. K. (2017a). Reservoir reconstruction technologies for coalbed methane recovery in deep and multiple seams. International Journal of Mining Science and Technology,17(2), 277–284. https://doi.org/10.1016/j.ijmst.2017.01.026.
Whittles, D. N., Lowndes, I. S., Kingman, S. W., Yates, C., & Jobling, S. (2006). Influence of geotechnical factors on gas flow experienced in a UK longwall coal mine panel. International Journal of Rock Mechanics and Mining Sciences,43(3), 369–387. https://doi.org/10.1016/j.ijrmms.2005.07.006.
Yan, Y. J., & Miao, L. X. (2009). Extremely thin protectors drilling picks the craft in protector mining application. Coal Technology,11, 005.
Yang, T. H., Xu, T., Liu, H. Y., Tang, C. A., Shi, B. M., & Yu, Q. X. (2011). Stress–damage–flow coupling model and its application to pressure relief coal bed methane in deep coal seam. International Journal of Coal Geology,86(4), 357–366. https://doi.org/10.1016/j.coal.2011.04.002.
Yuan, L. (2008). Theory and practice of integrated pillarless coal production and methane extraction in multiseams of low permeability. Beijing: China Coal Industry Publishing House.
Yuan, L. (2009). Theory of pressure-relieved gas extraction and technique system of integrated coal production and gas extraction. Journal of China Coal Society,34(1), 1–8.
Yuan, Y., Chen, Z. S., Xu, C. S., Zhang, X. W., & Wei, H. M. (2018). Permeability enhancement performance and its control factors by auger mining of extremely thin coal seams. Journal of Geophysics and Engineering,15, 2626–2641. https://doi.org/10.1088/1742-2140/aae068.
Zhang, C., Tu, S., & Zhang, L. (2018). Study of stress sensitivity of coal samples with different mining damage in overlying strata. Journal of China University of Mining and Technology,47(3), 502–511.
Zhang, C., Tu, S., Zhang, L., & Chen, M. (2016b). A study on effect of seepage direction on permeability stress test. Arabian Journal for Science and Engineering,41(11), 4583–4596. https://doi.org/10.1007/s13369-016-2215-2.
Zhang, C., Tu, S. H., Chen, M., & Zhang, L. (2016a). Pressure-relief and methane production performance of pressure relief gas extraction technology in the longwall mining. Journal of Geophysics and Engineering,14(1), 77. https://doi.org/10.1088/1742-2140/14/1/77.
Zhang, X. W. (2018). Study on the failure evolution of overlying rock and the seepage evolution of protected layer by drilling in Chiyu Mine. Xuzhou: China University of Mining and Technology.
Acknowledgments
Financial support for this work was provided by the National Key R&D Program of China (No. 2018YFC0604701), the Natural Science Foundation of Jiangsu Province (No. BK20181358), the Independent Research Project of State Key Laboratory of Coal Resources and Safe Mining, CUMT (SKLCRSM19X07), the National Natural Science Foundation of China (No. 51404249) and the Priority Academic Program Development of Jiangsu Higher Education Institutions.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Yuan, Y., Chen, Z., Yuan, C. et al. Numerical Simulation Analysis of the Permeability Enhancement and Pressure Relief of Auger Mining. Nat Resour Res 29, 931–948 (2020). https://doi.org/10.1007/s11053-019-09501-9
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11053-019-09501-9