Abstract
Research on microscopic bicycle flow parameters (speed, headway, spacing, and density) is limited given the lack of methods to collect data in large quantities automatically. This paper introduces a novel methodology to compute bicycle flow parameters based on a LiDAR system composed of two single-beam sensors. Instantaneous mid-block raw speed for each cyclist in the traffic stream is measured using LiDAR sensor signals at seven bidirectional and three unidirectional cycling facilities. A Multilayer Perception Neural Network is proposed to improve the accuracy of speed measures. The LiDAR system computes the headway and spacing between consecutive cyclists using time-stamped detections and speed values. Estimation of density is obtained using spacing. For model calibration and testing, 101 hours of video data collected at ten mid-block sites are used. The performance of the cyclist speed estimation is evaluated by comparing it to ground truth video. When the dataset is randomly split into training and test sets, the RMSE and MAPE of the speed estimation method on the test set are 0.61 m/s and 7.1%, respectively. In another scenario, when the model is trained with nine of the ten sites and tested on data from the remaining site, the RMSE and MAPE are 0.69 m/s and 8.2%, respectively. Lastly, the relationships governing hourly flow rate, average speed, and estimated density are studied. The data were collected during the peak cycling season at high-flow sites in Montreal, Canada; However, none of the facilities reached or neared capacity.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
Data availability
The cyclist’s hourly flow and speed data are available from the corresponding author upon request.
Code availability
The code of this study is available from the corresponding author upon request.
References
Bai, L., Liu, P., Chan, C.Y., Li, Z.: Estimating level of service of mid-block bicycle lanes considering mixed traffic flow. Transp. Res. Part a: Policy Pract. 101, 203–217 (2017). https://doi.org/10.1016/j.tra.2017.04.031
Beitel, D., Domínguez-Michelen, M., Miranda-Moreno, L.: The relationship between macroscopic cycling traffic parameters on cycle tracks. Paper presented at the Transportation Research Board 98th Annual Meeting, Washington D.C. (2019)
Berjisian, E., Bigazzi, A.: Extraction and investigation of bicycle cruising speeds from GPS data using time series clustering paper presented at the transportation research board 98th annual meeting, Washington D.C. (2019)
Johnson, P.C. Bicycle level of service: Where are the gaps in bicycle flow measures? Master thesis in Civil and Environmental Engineering. Portland State University (2014). https://doi.org/10.15760/etd.1974
Figliozzi, M., Wheeler, N., Monsere, C.M.: Methodology for estimating bicyclist acceleration and speed distributions at intersections. Transp. Res. Rec. 2387(1), 66–75 (2013). https://doi.org/10.3141/2387-08
Goñi-Ros, B., Yuan, Y., Daamen, W., Hoogendoorn, S.P.: Empirical analysis of the macroscopic characteristics of bicycle flow during the queue discharge process at a signalized intersection. Transp. Res. Rec. 2672(36), 51–62 (2018). https://doi.org/10.1177/0361198118790637
Greenshields, B.D., Bibbins, J.R., Channing, W.S., Miller, H.H.: A study of traffic capacity. Highway Research Board proceedings 1935 (1935)
Guo N., Jiang R., Wong S., Hao Q. Y., Xue S. Q., Hu M. B.: Bicycle flow dynamics on wide roads: Experiment and modeling. Preprint arXiv:06084 (2019)
Highway Capacity Manual. vol 1–4. Washington, DC (2000)
Hoogendoorn, S., Daamen, W.: Bicycle headway modeling and its applications. Transp. Res. Rec. 2587(1), 34–40 (2016). https://doi.org/10.3141/2587-05
Jeng, S.L., Chieng, W.H., Lu, H.P.: Estimating speed using a side-looking single-radar vehicle detector. IEEE Trans. Intell. Transp. Syst. 15(2), 607–614 (2014). https://doi.org/10.1109/TITS.2013.2283528
Jin, S., Qu, X., Zhou, D., Xu, C., Ma, D., Wang, D.: Estimating cycleway capacity and bicycle equivalent unit for electric bicycles. Transp. Res. Part a: Policy Pract. 77, 225–248 (2015). https://doi.org/10.1016/j.tra.2015.04.013
Lesani, A., Nateghinia, E., Miranda-Moreno, L.F.: Development and evaluation of a real-time pedestrian counting system for high-volume conditions based on 2D LiDAR. Transp. Res. Part C: Emerg. Technol. 114, 20–35 (2020). https://doi.org/10.1016/j.trc.2020.01.018
Liang, X., Xie, M., Jia, X.: New microscopic dynamic model for bicyclists’ riding strategies. J. Transp. Eng. Part a: Syst. 144(8), 04018034 (2018). https://doi.org/10.1061/JTEPBS.0000148
Lusk, A.C., Furth, P.G., Morency, P., Miranda-Moreno, L.F., Willett, W.C., Dennerlein, J.T.: Risk of injury for bicycling on cycle tracks versus in the street. Inj. Prev. 17(2), 131–135 (2011). https://doi.org/10.1136/ip.2010.028696
May, A.D.: Traffic Flow Fundamentals. Prentice Hall, Englewood Cliffs, NJ (1990)
Milakis, D., Cervero, R., Van Wee, B., Maat, K.: Do people consider an acceptable travel time? Evidence from Berkeley, CA. J. Transp. Geogr. 44, 76–86 (2015). https://doi.org/10.1016/j.jtrangeo.2015.03.008
Mohammed, H., Bigazzi, A.Y., Sayed, T.: Characterization of bicycle following and overtaking maneuvers on cycling paths. Transp. Res. Part C: Emerg. Technol. 98, 139–151 (2019). https://doi.org/10.1016/j.trc.2018.11.012
Nordback, K., Janson, B.N.: Automated bicycle counts: lessons from boulder, Colorado. Transp. Res. Rec. 2190(1), 11–18 (2010). https://doi.org/10.3141/2190-02
Nordback, K., Kothuri, S., Phillips, T., Gorecki, C., Figliozzi, M.: Accuracy of bicycle counting with pneumatic tubes in Oregon. Transp. Res. Rec. 2593(1), 8–17 (2016). https://doi.org/10.3141/2593-02
Romanillos, G., Gutierrez, J.: Cyclists do better. Analyzing urban cycling operating speeds and accessibility. Int J Sustain. Transp. 14(6), 448–464 (2020). https://doi.org/10.1080/15568318.2019.1575493
Saleh, K., Hossny, M., Hossny, A., Nahavandi, S.: Cyclist detection in LIDAR scans using faster R-CNN and synthetic depth images. In: IEEE 20th International Conference on Intelligent Transportation Systems (ITSC), Yokohama, Japan. (2017). https://doi.org/10.1109/ITSC.2017.8317599
Strauss, J., Miranda-Moreno, L.F.: Speed, travel time and delay for intersections and road segments in the montreal network using cyclist Smartphone GPS data. Transp. Res. Part D: Transp. Environ. 57, 155–171 (2017). https://doi.org/10.1016/j.trd.2017.09.001
Strauss, J., Miranda-Moreno, L.F., Morency, P.: Cyclist activity and injury risk analysis at signalized intersections: a Bayesian modelling approach. Accid. Anal. Prev. 59, 9–17 (2013). https://doi.org/10.1016/j.aap.2013.04.037
Twaddle, H., Grigoropoulos, G.: Modeling the speed, acceleration, and deceleration of bicyclists for microscopic traffic simulation. Transp. Res. Rec.: J. Transp. Res. Board 2587, 8–16 (2016). https://doi.org/10.3141/2587-02
Van Aerde, M., Rakha, H.: Multivariate calibration of single regime speed-flow-density relationships [road traffic management]. In: Pacific Rim TransTech conference. 1995 vehicle navigation and information systems conference proceedings. 6th international VNIS. A ride into the future, Seattle, WA. IEEE, pp 334–341 (1995). https://doi.org/10.1109/VNIS.1995.518858
Xu, C., Li, Q., Qu, Z., Tao, P.: Modeling of speed distribution for mixed bicycle traffic flow. Adv. Mech. Eng. 7(11), 1687814015616918 (2015)
Zaki, M.H., Sayed, T.: Automated cyclist data collection under high density conditions. IET Intel. Transport Syst. 10(5), 361–369 (2016). https://doi.org/10.1049/iet-its.2014.0257
Zaki, M., Sayed, T., Cheung, A.: Computer vision techniques for the automated collection of cyclist data. Transp. Res. Rec.: J. Transp. Res. Board 2387(1), 10–19 (2013). https://doi.org/10.3141/2387-02
Zhao, Y., Zhang, H.M.: A unified follow-the-leader model for vehicle, bicycle and pedestrian traffic. Transp. Res. Part B: Methodol. 105, 315–327 (2017). https://doi.org/10.1016/j.trb.2017.09.004
Acknowledgements
Funding for this project is provided in part by the Natural Sciences and Engineering Research Council (NSERC).
Author information
Authors and Affiliations
Contributions
The authors confirm contribution to the paper as follows: study conception and design: E. Nateghinia, A. Lesani, D. Beitel, and L. F. Miranda-Moreno; data collection: A. Lesani, and D. Beitel; data processing and system modeling: E. Nateghinia; analysis and interpretation of results: E. Nateghinia, and D. Beitel; draft manuscript preparation: E. Nateghinia, D. Beitel, and L. F. Miranda-Moreno. All authors reviewed the results and approved the final version of the manuscript.
Corresponding author
Ethics declarations
Conflict of interest
The authors confirm that there are no known conflicts of interest associated with this publication.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
An early version of this research was presented at the 99th TRB Annual Meeting in January 2020.
Rights and permissions
Springer Nature or its licensor holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Nateghinia, E., Beitel, D., Lesani, A. et al. A LiDAR-based methodology for monitoring and collecting microscopic bicycle flow parameters on bicycle facilities. Transportation 51, 129–153 (2024). https://doi.org/10.1007/s11116-022-10322-8
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11116-022-10322-8