Skip to main content
Log in

A Numerical Implementation of the Three-Dimensional Viscoelastic Model for Asphalt Mastic

  • Research Paper
  • Published:
International Journal of Civil Engineering Aims and scope Submit manuscript

Abstract

This paper presents a numerical implementation of the three-dimensional viscoelastic model to describe the behavior of asphalt mastic. Details of the numerical viscoelastic constitutive formulation implemented in a finite element code are presented and illustrated. Then, uniaxial tensile tests and torsion tests were conducted to determine the viscoelastic constitutive parameters at a temperature of 20 °C. Both the capability of the model and the accuracy of the parameter determination of the displacement-based constitutive numerical model were examined by comparing the numerical predictions with the observed laboratory tests under two basic loading paths. The presented results show that the numerical predictions exhibit a rather good agreement with the experimental results for three primary modes of bending and compression loading. Therefore, the presented numerical implementation of constitutive model may be appropriate for describing the mechanical behavior of asphalt mastic when the viscoelastic constitutive parameters became available.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9

Similar content being viewed by others

References

  1. Masad E, Jandhyala V, Dasgupta N, Somadevan N, Shashidhar N (2002) Characterization of air void distribution in asphalt mixes using X-ray computed tomography. J Mater Civ Eng 14:122

    Article  Google Scholar 

  2. Gruber I, Zinovik I, Holzer L, Flisch A, Poulikakos LD (2012) A computational study of the effect of structural anisotropy of porous asphalt on hydraulic conductivity. Constr Building Mater 36:66

    Article  Google Scholar 

  3. Coleri E, Harvey JT, Yang K, Boone JM (2012) A micromechanical approach to investigate asphalt concrete rutting mechanisms. Constr Building Mater 30:36

    Article  Google Scholar 

  4. Manahiloh K, Muhunthan B, Kayhanian M, Gebremariam S (2012) X-Ray computed tomography and nondestructive evaluation of clogging in porous concrete field samples. J Mater Civ Eng 24:1103

    Article  Google Scholar 

  5. Wan C, Zhang X, Wang L, He L (2012) Three-dimensional micromechanical finite element analysis on gauge length dependency of the dynamic modulus of asphalt mixtures. Road Mater Pavement Design 13:769

    Article  Google Scholar 

  6. Coleri E, Harvey JT, Yang K, Boone JM (2012) Development of a micromechanical finite element model from computed tomography images for shear modulus simulation of asphalt mixtures. Constr Building Mater 30:783

    Article  Google Scholar 

  7. Ying H, Elseifi M, Mohammad L, Hassan M (2013) Heterogeneous finite-element modeling of the dynamic complex modulus test of asphalt mixture using X-ray computed tomography. J Mater Civ Eng 26:4014052

    Article  Google Scholar 

  8. Onifade I, Jelagin D, Guarin A, Birgisson B, Kringos N (2013) Asphalt internal structure characterization with X-ray computed tomography and digital image processing. Springer, Netherlands, Dordrecht

    Book  Google Scholar 

  9. Dai Q (2011) Two- and three-dimensional micromechanical viscoelastic finite element modeling of stone-based materials with X-ray computed tomography images. Constr Building Mater 25:1102

    Article  Google Scholar 

  10. Kaliske M, Rothert H (1997) Formulation and implementation of three-dimensional viscoelasticity at small and finite strains. Comput Mech 19:228

    Article  MATH  Google Scholar 

  11. Zhu Q, Shrotriya P, Sottos NR, Geubelle PH (2003) Three-dimensional viscoelastic simulation of woven composite substrates for multilayer circuit boards. Compos Sci Technol 63:1971

    Article  Google Scholar 

  12. Hinterhoelzl RM, Schapery RA (2004) FEM implementation of a three-dimensional viscoelastic constitutive model for particulate composites with damage growth. Mech Time Depend Mater 8:65

    Article  Google Scholar 

  13. Liu M, Hoo Fatt MS (2009) A three-dimensional constitutive model for the dynamic response of rubber. Tire Sci Technol 37:226

    Article  Google Scholar 

  14. Dai Q, You Z (2010) A microstructure-based approach for simulating viscoelastic behaviors of asphalt mixtures. Proceedings of sessions of GeoShanghai 2010, 150 p

  15. Kim Y, Lutif J (2008) Computational micromechanics modeling for damage-induced behavior of asphalt mixtures considering viscoelasticity and cohesive zone fracture. Proceedings of Pavements and Materials: modeling, testing, and performance. American Society of Civil Engineers, 17 p

  16. Dai Q (2009) Prediction of dynamic modulus and phase angle of stone-based composites using a micromechanical finite-element approach. J Mater Civ Eng 22:618

    Article  Google Scholar 

  17. Mott PH, Dorgan JR, Roland CM (2008) The bulk modulus and Poisson’s ratio of “incompressible” materials. J Sound Vib 312:572

    Article  Google Scholar 

  18. Belabdelouahab F, Trouzine H, Hellal H, Rahali B, Kaci SO, Medine M (2016) Comparative analysis of estimated young’s modulus of rubberized mortar and concrete. Int J Civ Eng 2016:1

    Google Scholar 

  19. Djellali A, Houam A, Saghafi B, Hamdane A, Benghazi Z (2016) Static analysis of flexible pavements over expansive soils. Int J Civ Eng, p 1

  20. Rashadul Islam M, Faisal HM, Tarefder RA (2015) Determining temperature and time dependent Poisson’s ratio of asphalt concrete using indirect tension test. Fuel 146:119

    Article  Google Scholar 

  21. Gudmarsson A, Ryden N, Di Benedetto H, Sauzéat C (2015) Complex modulus and complex Poisson’s ratio from cyclic and dynamic modal testing of asphalt concrete. Constr Building Mater 88:20

    Article  Google Scholar 

  22. Allou F, Takarli M, Dubois F, Petit C, Absi J (2015) Numerical finite element formulation of the 3D linear viscoelastic material model: Complex Poisson’s ratio of bituminous mixtures. Arch Civ Mech Eng 15:1138

    Article  Google Scholar 

  23. Wen-ke H, Li-juan Z, Xiao-ning Z, Shen-shen S (2015) Research on the conversion relationship between relaxation modulus and creep compliance of asphalt mixture based on Prony series. J Transp Sci Eng 31:7. (in Chinese)

    Google Scholar 

Download references

Acknowledgements

The funding was provided by National Natural Science Foundation of China (CN), (Grant No. 51508109).

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Xiaoning Zhang.

Ethics declarations

Conflict of interest

The authors declare that they have no conflict of interest.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Huang, W., Zhang, X., Yin, Y. et al. A Numerical Implementation of the Three-Dimensional Viscoelastic Model for Asphalt Mastic. Int J Civ Eng 16, 543–551 (2018). https://doi.org/10.1007/s40999-017-0160-4

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s40999-017-0160-4

Keywords

Navigation