Abstract
Experimental and theoretical studies have been performed to clarify the ability of flowing groundwater in contact with bentonite to generate bentonite colloidal particles and disperse such colloids. This information is required to determine (a) the long-term stability of bentonite as a buffer material for borehole disposal of radioactive wastes in deep geologic media and (b) the potential influence of bentonite colloidal particles on radionuclide transport, specifically for use in scenario analyses in the performance assessment of waste disposal.
In this study, the minimum groundwater velocity required to erode particles of Nabentonite or Ca-bentonite from a bentonite surface in contact with groundwater was derived from shear strengths of aqueous bentonite gel suspensions, as determined by viscometer tests. The shear strengths were used to estimate the corresponding shear force on bentonite particle-particle bonds, using an estimated value for the number of initial bentonite particle-particle bonds in the experimental systems studied. The derived shear force was converted to corresponding groundwater velocity by using Stokes’ equation and simplifying assumptions. The results indicate that groundwater velocities in a range of about 10−5 to 10−4 m/s would be required to initiate bentonite erosion. This range is higher than the groundwater flow velocity generally found in deep geologic media in Japan. In addition, known groundwater electrolyte concentrations were compared with theoretical estimates of aqueous electrolyte concentrations required to flocculate colloidal bentonite particles (for example 1 × 10−3 mol/l Na+). The comparison indicates that, even if erosion of bentonite occurred, the colloidal bentonite particles formed would flocculate. As a result, this study has shown that the effect of bentonite colloids on radionuclide transport is likely to be negligible in the performance assessment of radioactive waste disposal in deep geologic media.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
R. Pusch, SKB Technical Report 83-04, 1983.
S. H. Nickel, in ASTM STP 623, edited by J. L. Sherard and R. S. Decker (American Society for Testing and Materials, 1977), pp. 303–312.
R. Pusch, M. Erlstnom and L. Borgesson, SKB Technical Report 87-09, 1987.
K. Yanagizawa, K. Furuya, H. Ohsawa, H. Wakamatsu and K. Umeda, PNC TN7410 92-015, 1992 (in Japanese with English abstract).
H. van Olphen, An Introduction to clay colloid chemistry, 2nd ed. (A Wiley Interscience Publisher, New York, 1977), p. 32.
H. R. Kruyt, Colloid Science, 1st ed. (Elsevier Publishers, New York, 1952), pp.245–306.
J. Visser, Advances in Colloid and Interface Science, 3, 331(1972).
Y. Ochiai, M. Yamakawa, S. Takeda, and H. Harashima, Report of the 3rd Meeting of CEC Natural Analogue Working Group, pp. 126–138, 1988.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Kurosawa, S., Kato, H., Ueta, S. et al. Erosion Properties and Dispersion-Flocculation Behavior of Bentonite Particles. MRS Online Proceedings Library 556, 679 (1998). https://doi.org/10.1557/PROC-556-679
Published:
DOI: https://doi.org/10.1557/PROC-556-679