Abstract
Microstructure and electrochemical behavior of stainless steel weld overlay cladding exposed to post weld heat treatment (PWHT) were investigated, wherein pitting and intergranular corrosion behaviors of the cladding material were evaluated by potentiodynamic polarization and double loop electrochemical potentiokinetic reactivation methods. The results indicated that inclusions, multiple element (Mn, Si, and Al) oxides distributed randomly in the cladding material with a size less than 1 µm. PWHT contributed to carbides precipitation along the δ/γ phase interface and the formation of Cr-depleted zone in the austenite phase. Inclusions acted as the pitting sites in the sample as welded. PWHT reduced the pitting potential and contributed to the formation of larger and deeper pits, which nucleated around the δ/γ phase interface primarily. Existence of carbides and Cr-depleted zone dominated the loss of intergranular corrosion resistance after PWHT.
Similar content being viewed by others
References
S.L. Li, Y.L. Wang, H.L. Zhang, S.X. Li, K. Zhang, F. Xue, and X.T. Wang: Microstructure evolution and impact fracture behaviors of Z3CN20-09M stainless steels after long-term thermal aging. J. Nucl. Mater. 433 (1–3), 41 (2013).
R. Unnikrishnan, K.S.N.S. Idury, T.P. Ismail, A. Bhadauria, S.K. Shekhawat, R.K. Khatirkar, and S.G. Sapate: Effect of heat input on the microstructure, residual stresses and corrosion resistance of 304L austenitic stainless steel weldments. Mater. Charact. 93 (7), 10 (2014).
Y. Cui and C.D. Lundin: Austenite-preferential corrosion attack in 316 austenitic stainless steel weld metals. Mater. Des. 28 (1), 324 (2007).
R. Badji, B. Bacroix, and M. Bouabdallah: Texture, microstructure and anisotropic properties in annealed 2205 duplex stainless steel welds. Mater. Charact. 62 (9), 833 (2011).
G.F. Li, E.A. Charles, and J. Congleton: Effect of post weld heat treatment on stress corrosion cracking of a low alloy steel to stainless steel transition weld. Corros. Sci. 43 (10), 1963 (2001).
G.F. Li and J. Congleton: Stress corrosion cracking of a low alloy steel to stainless steel transition weld in PWR primary waters at 292 °C. Corros. Sci. 42 (6), 1005 (2000).
T. Takeuchi, Y. Takuyo, M. Tomoki, A. Koji, and F. Koji: Corrosion behavior of stainless steels in simulated PWR primary water-effect of chromium content in alloys and dissolved hydrogen. J. Nucl. Sci. Technol. 45 (10), 975 (2008).
A. Abbasi Aghuy, M. Zakeri, M.H. Moayed, and M. Mazinani: Effect of grain size on pitting corrosion of 304L austenite stainless steel. Corros. Sci. 94, 368 (2015).
H-Y. Ha, M-H. Jang, and T-H. Lee: Influence of Mn in solid solution on pitting corrosion behavior of Fe–23 wt% Cr-based alloys. Corros. Sci. 191 (10), 864 (2016).
Y.H. Yang, B. Yan, J. Wang, and J.L. Li: The influence of solution treatment temperature on microstructure and corrosion behavior of high temperature ageing in 25% Cr duplex stainless steel. J. Alloys Compd. 509 (36), 8870 (2011).
J.L. Cardoso and R.C.A. Vieira: Pitting corrosion resistance of austenitic and superaustenitic stainless steels in aqueous medium of NaCl and H2SO4. J. Mater. Res. 31 (12), 1755 (2016).
A. Pardo, M.C. Merino, A.E. Coy, F. Viejo, R. Arrabal, and E. Matykina: Pitting corrosion behaviour of austenitic stainless steels-combining effects of Mn and Mo additions. Corros. Sci. 50 (6), 1796 (2008).
R. Ke and R. Alkire: Initiation of corrosion pits at inclusions on 304 stainless steel. J. Electrochem. Soc. 139 (6), 1573 (1992).
A. Otake, I. Muto, A. Chiba, Y. Sugawara, and N. Hara: Microelectrochemical investigation of pit initiation site on austenitic cast stainless steel. ECS Trans. 69 (28), 1 (2015).
I. Lo and W.T. Tsai: Effect of heat treatment on the precipitation and pitting corrosion behavior of 347 SS weld overlay. Mater. Sci. Eng., A 355 (1), 137 (2003).
Z.Y. Zhu, C.Y. Deng, Y. Wang, Z.W. Yang, J.K. Ding, and D.P. Wang: Effect of post weld heat treatment on the microstructure and corrosion behavior of AA2219 aluminum alloy joints welded by variable polarity tungsten inert gas welding. Mater. Des. 65, 1075 (2015).
Y. Yang, Z. Wang, H. Tan, J.F. Hong, Y.M. Jiang, L.Z. Jiang, and J. Lin: Effect of a brief post-weld heat treatment on the microstructure evolution and pitting corrosion of laser beam welded UNS S31803 duplex stainless steel. Corros. Sci. 65 (9), 472 (2012).
K. Guan, X. Xu, H. Xu, and Z. Wang: Effect of aging at 700 °C on precipitation and toughness of AISI 321 and AISI 347 austenitic stainless steel welds. Nucl. Eng. Des. 235 (23), 2485 (2005).
G. Bai, S. Lu, D. Li, and Y. Li: Intergranular corrosion behavior associated with delta-ferrite transformation of Ti-modified Super 304H austenitic stainless steel. Corros. Sci. 90, 347 (2015).
V.S. Moura, L.D. Lima, J.M. Pardal, and S.S.M. Tavares: Influence of microstructure on the corrosion resistance of the duplex stainless steel UNS S31803. Mater. Charact. 59 (8), 1127 (2008).
J.H. Liu, Y. Wen, X.M. Zhang, S.M. Huo, and B. Gong: Corrosion properties of sealing surface material for RPV under abnormal working conditions. Nucl. Power Eng. 33 (1), 83 (2012).
Z. Fang, Y.L. Zhang, Y.S. Wu, D.B. Sun, and J.Q. Li: Detecting susceptible to intergranular corrosion of 308L stainless steel by EPR method. Corros. Sci. Prot. Technol. 8, 87 (1996).
Y.M. Tang, Y. Zuo, J.N. Wang, X.H. Zhao, B. Niu, and B. Lin: The metastable pitting potential and its relation to the pitting potential for four materials in chloride solutions. Corros. Sci. 80 (3), 111 (2014).
X. Di, S. Ji, F. Cheng, and J. Cao: Effect of cooling rate on microstructure, inclusions and mechanical properties of weld metal in simulated local dry underwater welding. Mater. Des. 88, 505 (2015).
H.Y. Ha, M.H. Jang, and T.H. Lee: Influences of Mn in solid solution on the pitting corrosion behaviour of Fe-23 wt% Cr-based alloys. Electrochim. Acta 191, 864 (2016).
Z.Q. Sheng: The intercrystalline corrosion in the stainless bead welding layer. Nucl. Power Eng. 11, 48 (1990).
D. Nakhaie and M.H. Moayed: Pitting corrosion of cold rolled solution treated 17-4 PH stainless steel. Corros. Sci. 80 (3), 290 (2014).
ACKNOWLEDGMENTS
The authors acknowledge the financial support for the present work from National Energy Application Technology Research and Engineering Demonstration Project (NY20111201-1).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Cao, X.Y., Zhu, P., Liu, T.G. et al. Microstructure and electrochemical behavior of stainless steel weld overlay cladding exposed to post weld heat treatment. Journal of Materials Research 32, 852–862 (2017). https://doi.org/10.1557/jmr.2016.526
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1557/jmr.2016.526