Skip to main content
Log in

Ground Truth Location of Earthquakes by Use of Ambient Seismic Noise From a Sparse Seismic Network: A Case Study in Western Australia

  • Published:
Pure and Applied Geophysics Aims and scope Submit manuscript

Abstract

The estimated Green’s function (EGF) extracted from the ambient seismic noise cross-correlation function (NCF) enables valuable calibration of surface wave propagation along the path connecting seismic stations. Such calibration is adopted in a new method for ground truth location of earthquakes, achieved from the location relative to a seismic station. The surface wave group travel times were obtained from the NCFs between a station near the earthquake and remote stations. The differential travel times from the NCFs and the surface wave of the earthquake were used in a relative location procedure. When this method was applied to earthquake location with only six seismic stations in western Australia, the location of the Mw 4.1 Kalannie (September 21, 2005) earthquake was found to be accurate to within 2 km compared with the ground truth location with InSAR for which azimuth coverage of seismic stations is preferable. Synthetic tests suggest that the group travel time is slightly affected by focal mechanism and focal depth, thus unknown earthquake source parameters did not introduce substantial bias to earthquake location with the group travel time method.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9

Similar content being viewed by others

References

  • Barmin M. P., A. L. Levshin, Y. Yang, and M. H. Ritzwoller (2011), Epicentral Location Based on Rayleigh Wave Empirical Green’s Functions from Ambient Seismic Noise, Geophys. J. Int., 184(2), 869–884.

  • Bassin, C. (2000), The current limits of resolution for surface wave tomography in North America, EOS Trans. AGU., 81, F897.

  • Bensen, G. D., M. H. Ritzowoller, M. P. Barmin, A. L. Levshin, F. Lin, M. P. Moschetti, N. M. Shapiro, and Y. Yang (2007), Processing seismic ambient noise data to obtain reliable broad-band surface wave dispersion measurements, Geophys. J. Int., 169(3), 1239–1260.

  • Bondar, I., and K. L. McLaughlin (2009), A new ground truth data set for seismic studies, Seismol. Res. Lett., 80(3), 465–472.

  • Cleveland, K. M., and C. J. Ammon (2013), Precise relative earthquake location using surface waves, J. Geophys. Res. Solid Earth, 118, 2893–2904, doi:10.1002/jgrb.50146.

  • Collins, C., R. Kayen, B. Carkin, A. Trevor, P. Cummins, and A. McPherson (2006), Shear wave velocity measurement at Australian ground motion seismometer sites by the spectral analysis of surface waves (SASW) method, paper presented at 2006 The Australian Earthquake Engineering Society Conference Proceedings, Canberra, ACT.

  • Crone, A. J., M. N. Machette, and J. Bowman (1997), Episodic nature of earthquake activity in stable continental regions revealed by palaeoseismicity studies of Australian and North American quaternary faults, Aust. J. Earth Sci., 44(2), 203–214.

  • Crough S. and R. Van der voo (1973), A method for relocating seismic events using surface waves, Bull. Seismol. Soc. Am., 63(4), 1305–1313.

  • Dawson, J., P. Cummins, P. Tregoning, and M. Leonard (2008), Shallow intraplate earthquakes in Western Australia observed by Interferometric Synthetic Aperture Radar, J. Geophys. Res., 113, B11408, doi:10.1029/2008JB005807.

  • Ekstrom G. (2006), Global detection and location of seismic sources by using surface waves, Bull. Seismol. Soc. Am., 96, 4A, 1201–1212.

  • Everingham, I. B., P. J. Gregson, and H. A. Doyle (1969), Thrust fault scarp in the Western Australian shield, Nature, 223, 701–703.

  • Flanagan, M. P., S. C. Mayers, and K. D. Koper (2007), Regional traveltime uncertainty and seismic location improvement using a three dimensional a priori velocity model, Bull. Seismol. Soc. Am., 97, 804–825.

  • Hauksson, E. and J. S. Haase (1997), Three-dimensional V P and V P /V S Velocity Models of the Los Angeles basin and central Transverse Ranges, California, J. Geophys. Res., 102(B3), 5423–5453, doi:10.1029/96JB03219.

  • Herrmann, R. B. (2003), Computer Programs in Earthquake Seismology, by Dept. Earth and Atmosph. Sciences, Saint Lois University.

  • Leonard, M. (2008), One hundred years of earthquake recording in Australia, Bull. Seismol. Soc. Am., 98, 1458–1470.

  • Levshin, A.L., M.H. Ritzwoller, and J.S. Resovsky (1999), Source effects on surface wave group travel times and group velocity maps, Phys. Earth Planet. Int., 115, 293–312.

  • Levshin, A. L., M. P. Barmin, M. P. Moschetti, C. Mendoza, and M. H. Ritzwoller (2012), Refinements to the method of epicentral location based on surface waves from ambient seismic noise: Introducing Love waves, Geophys. J. Int. doi:10.1111/j.1365-246X.2012.05631.x.

  • Lin, F. C., V. C. Tsai, B. Schmandt, Z. Duputel, and Z. Zhan (2013). Extracting seismic core phases with array interferometry. Geophysical Research Letters, 40(6), 1049–1053.

  • Mayers S. and C. Schultz (2000), Improving Sparse Network Seismic Location with Bayesian Kriging and Teleseismically Constrained Calibration Events, Bull. Seis. Soc. Am, 90(1), 199–211.

  • Myers, J. S. (1993), Precambrian history of the West Australian craton andadjacent orogens, Annu. Rev. Earth Planet. Sci., 21, 453–485.

  • Nishida, K. (2013). Global propagation of body waves revealed by cross‐correlation analysis of seismic hum. Geophysical Research Letters, 40(9), 1691–1696.

  • Poli, P., M. Campillo and H. Pedersen (2012). Body-wave imaging of earth’s mantle discontinuities from ambient seismic noise. Science, 338(6110), 1063–1065.

  • Poupinet, G., W. L. Ellsworth, and J. Frechet (1984), Monitoring Velocity Variations in the Crust Using Earthquake Doublets: An Application to the Calaveras Fault, California, J. Geophys. Res., 89(B7), 5719–5731, doi:10.1029/JB089iB07p05719.

  • Roux, P., K. G. Sabra, P. Gerstoft, W. A. Kuperman, and M. C. Fehler (2005), P-waves from cross-correlation of seismic noise, Geophys. Res. Lett., 32, L19303, doi:10.1029/2005GL023803.

  • Schaff, D. and P. Richards (2004), Lg-wave cross correlation and double-difference location: Application to the 1999 Xiuyan, China, sequence, Bull. Seismol. Soc. Am. 94, 867–879.

  • Shapiro, N M, and M Campillo. (2004), Emergence of broadband Rayleigh waves from correlations of the ambient seismic noise, Geophys. Res. Lett., 31, L07614, doi:10.1029/2004GL019491.

  • Shearer, P. M. (1997), Improving local earthquake locations using the L1 norm and waveform cross correlation: Application to the Whittier Narrows, California, aftershock sequence, J. Geophys. Res., 102(B4), 8269–8283, doi:10.1029/96JB03228.

  • Tsai, Y.-B., and K. Aki (1970), Precise Focal Depth Determination from Amplitude Spectra of Surface Waves, J. Geophys. Res., 75(29), 5729–5744, doi:10.1029/JB075i029p05729.

  • Waldhauser, F. and W. Ellsworth, (2000), Double-Difference Earthquake Location Algorithm: Method and Application to the Northern Hayward Fault, California, Bull. Seis. Soc. Am, 90(6), 1353–1368.

  • Xie, J., X. Zeng, W. Chen, and Z. Zhan (2011), Comparison of ground truth location of earthquake from InSAR and from ambient seismic noise: A case study of the 1998 Zhangbei earthquake. Earthquake Science, 24(2), 239–247.

  • Yang Y. and M. Ritzwoller (2008), Characteristics of ambient seismic noise as a source for surface wave tomography, Geochem. Geophys. Geosyst., 9, Q02008, doi:10.1029/2007GC001814.

  • Zhan Z., S. Ni, D. V. Helmberger and R. W. Clayton. (2010), Retrieval of Moho-reflected shear wave arrivals from ambient seismic noise. Geophys. J. Int., 182, 408–420.

  • Zhan Z., Wei, S., S. Ni, and D.V. Helmberger (2011), Earthquake centroid locations using calibration from ambient seismic noise. Bull. Seismlo. Soc. Am. 101(3), 1438–1445.

  • Zhu, L., and L. A. Rivera (2002), A note on the dynamic and static displacements from a point source in multilayered media. Geophys. J. Int., 148(3), 619–627.

  • Zhu L., Y. Tan, D. V. Helmberger, and C. K. Saikia (2006), Calibration of the Tibetan plateau using regional seismic waveforms. Pure appl. geophys.

Download references

Acknowledgments

The authors would like to thank IRIS DMC for providing the waveforms and Austria Geoscience for providing the catalogue. Financial support from the Chinese Academy of Sciences (Grant number. KZCX2-EW-121), the National Key Basic Research Program of China (Grant Nos 2013CB733203 and 2014CB845905), and the National Natural Science Foundation of China (Grant Nos. 41204044 and 41274069) is gratefully acknowledged.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Sidao Ni.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Zeng, X., Xie, J. & Ni, S. Ground Truth Location of Earthquakes by Use of Ambient Seismic Noise From a Sparse Seismic Network: A Case Study in Western Australia. Pure Appl. Geophys. 172, 1397–1407 (2015). https://doi.org/10.1007/s00024-014-0993-6

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s00024-014-0993-6

Keywords

Navigation