Abstract
The evolution of rock mass cracks is particularly important for the study of the rock mass fracture instability and catastrophic mechanism of underground engineering. To investigate the fracture characteristics of deep rock mass and formation mechanism of the water inrush channel and based on the real measured data of water-inrush mines, this paper divides floor mining cracks into shear cracks, layer cracks, and vertical tensile cracks according to the location of the cracks. Knowledge of mechanics is utilized to analyze the crack-initiating and growing principles of floor mining cracks to disclose the coupling relationship between mining-induced cracks and principle stress and hydraulic pressure. Based on a self-developed simulation test system for high-pressure floor water inrush, a model of crack evolution and channel formation for the deep floor above confined water is established. Through installing stress sensors and displacement-monitoring spots at different depths of the floor, the stress and displacement variation characteristics of floor rock mass during mining are obtained, and the development and evolution patterns of floor mining cracks are deduced. This research shows that the mining-induced cracks of the deep floor rock mass are mainly produced in three parts: open-off cut, the middle of the goaf, and the actual mining face; the crack types mainly include vertical tensile cracks, shear cracks, and layer cracks, and some small cracks have developed near the main cracks; in the process of mining, the mining-induced cracks evolve and penetrate through each other along the direction of the principle stress, and finally the water inrush channel is formed. In an actual coal seam mining process, it is necessary to monitor the crack state of these three parts of the rock mass and the pressure variation of the confined water. The research results can provide new guidelines for the management of deep water inrush disasters and the mining safety of coal resources.
Similar content being viewed by others
References
Afolagboye, L. O., He, J. M., & Wang, S. J. (2017). Experimental study on cracking behaviour of moulded gypsum containing two non-parallel overlapping flaws under uniaxial compression. Acta Mechanica Sinica, 33(2), 394–405.
Bai, J. W., Li, S. C., Liu, R. T., Zhang, Q. S., Zhang, H. J., & Sha, F. (2015). Multi-field information monitoring and warning of delayed water bursting in deep rock fault. Chinese Journal of Rock Mechanics and Engineering, 34(11), 2327–2335.
Blaheta, R., Kohut, R., Kolcun, A., Souek, K., Stas, L., & Vavro, L. (2015). Digital image based numerical micromechanics of geocomposites with application to chemical grouting. International Journal of Rock Mechanics and Mining Sciences, 77, 77–88.
Chen, S. H., Xue, L. L., Xu, G. S., & Shahrour, I. (2010). Composite element method for the seepage analysis of rock masses containing fractures and drainage holes. International Journal of Rock Mechanics and Mining Sciences, 47(5), 762–770.
Chen, J. T., Yin, L. M., Sun, W. B., Lu, C., Zhang, S. C., & Sun, X. Z. (2015). Development and application for new solid-fluid coupling similar material of deep floor aquifuge. Chinese Journal of Rock Mechanics and Engineering, 34(S2), 3956–3964.
Gong, B., Jiang, Y., & Chen, L. (2019). Feasibility investigation of the mechanical behavior of methane hydrate-bearing specimens using the multiple failure method. Journal of Natural Gas Science and Engineering, 2019(69), 102915.
Gong, B., Jiang, Y., & Yan, P. (2020). Discrete element numerical simulation of mechanical properties of methane hydrate-bearing specimen considering deposit angles. Journal of Natural Gas Science and Engineering, 2020(76), 103182.
Guo, W. J., Zhang, S. C., Sun, W. B., & Chen, J. T. (2018). Experimental and analysis research on water inrush catastrophe mode from coal seam floor in deep mining. Journal of China Coal Society, 43(1), 219–227.
Guy, N., Seyedi, D. M., & Hild, F. (2018). Characterizing fracturing of clay-rich lower watrous rock: From laboratory experiments to nonlocal damage-based simulations. Rock Mechanics and Rock Engineering, 51(6), 1777–1787.
Haer, H. (2015). Crack analysis of pre-cracked brittle specimens under biaxial compression. Journal of Mining Science, 51(6), 1091–1100.
Hu, W. Y., & Yin, S. X. (2010). Dynamic mechanism of water inrush from floor of mining face. Chinese Journal of Rock Mechanics and Engineering, 29(S1), 3344–3349.
Hu, W. Y., & Zhou, J. J. (2017). Discussion on some confused key concepts used in mine water disaster control and protection. Coal Science and Technology, 45(8), 60–65.
Hu, W. Y., Zhu, K. P., & Huang, X. M. (2010). Study on floor rock mass failure and water inrush caused by non-uniform distributed water pressure in mining face. Journal of China Coal Society, 35(7), 1109–1114.
Huang, R. Q., Wang, X. N., & Chen, L. S. (2000). Hydro-splitting off analysis on underground water in deep-lying tunnels and its effect on water gushing out. Chinese Journal of Rock Mechanics and Engineering, 19(5), 573–576.
Jiang, F. X. (2004). Underground pressure and strata control. China: China Coal Industry Publishing House.
Jinhai, Z., Ning, J., Liming, Y., & Li-yang, B. (2019). The effects of mining subsidence and drainage improvements on a waterlogged area. Bulletin of Engineering Geology and the Environment, 78(5), 3815–3831. https://doi.org/10.1007/s10064-018-1356-9.
Li, H. C. (1988). Similar simulation testing for mine pressure. Beijing: China University of Mining and Technology.
Li, S. C., Li, Y. C., Wang, G., & Bai, S. W. (2007). CT real-time scanning tests on rock specimens with artificial initial crack under uniaxial conditions. Chinese Journal of Rock Mechanics and Engineering, 26(3), 484–492.
Li, Z., Liu, H. X., Dun, Z. L., Ren, L. W., & Fang, J. J. (2020). Grouting effect on rock fracture using shear and seepage assessment. Construction and Building Materials, 242, 118131. https://doi.org/10.1016/j.conbuildmat.2020.118131.
Li, L. C., Tang, C. A., Li, G., & Yang, T. H. (2009a). Damage evolution and delayed groundwater inrush from micro faults in coal seam floor. Chinese Journal of Geotechnical Engineering Chinese Edition, 31(12), 1838–1844.
Li, L. C., Tang, C. A., Liang, Z. Z., Ma, T. H., & Zhang, Y. B. (2009b). Dynamic numerical analysis of pathway formation of groundwater inrush from faults in coal seam floor. Chinese Journal of Rock Mechanics and Engineering, 28(2), 290–297.
Liu, Z. J., & Hu, Y. Q. (2007). Solid–liquid coupling study on water inrush through faults in coal mining above confined aquifer. Journal of China Coal Society, 32(10), 1046–1050.
Liu, H. Y., Lv, S. R., Zhang, L. M., & Yuan, X. P. (2015). A dynamic damage constitutive model for a rock mass with persistent joints. International Journal of Rock Mechanics and Mining Sciences, 75, 132–139.
Liu, J. F., Yang, H. Q., Xiao, Y., & Zhou, X. P. (2018). Macro-mesoscopic fracture and strength character of pre-cracked granite under stress relaxation condition. Rock Mechanics and Rock Engineering, 51(5), 1401–1412.
Modiriasari, A., Bobet, A., & Pyrak-Nolte, L. J. (2017). Active seismic monitoring of crack initiation, propagation, and coalescence in rock. Rock Mechanics and Rock Engineering, 50(9), 2311–2325.
Mohaddeseh, M. N., Quentin, J. F., Elia, G., & Mohammad, R. (2018). Experimental study and numerical modeling of fracture propagation in shale rocks during Brazilian disk test. Rock Mechanics and Rock Engineering, 51(6), 1755–1775.
Munoz, H., Taheri, A., & Chanda, E. (2016a). Pre-peak and post-peak rock strain characteristics during uniaxial compression by 3D digital image correlation. Rock Mechanics and Rock Engineering, 49(7), 2541–2554.
Munoz, H., Taheri, A., & Chanda, E. (2016b). Fracture energy-based brittleness index development and brittleness quantification by pre-peak strength parameters in rock uniaxial compression. Rock Mechanics and Rock Engineering, 49(12), 4587–4606.
Shen, M. R., & Chen, J. F. (2006). Rock mass mechanics. Shanghai: Tongji University Press.
Sun, W. B. (2013). Basic experimental study on formation and evolution of water-inrush pathway from floor under confined water of high pressure in deep mining. Qingdao: Shandong University of Science and Technology.
Sun, W. B., Zhang, S. C., Guo, W. J., & Liu, W. T. (2017). Physical simulation of high-pressure water inrush through the floor of a deep mine. Mine Water and the Environment, 36(4), 542–549.
Tan, X., Konietzky, H., & Chen, W. (2016). Numerical simulation of heterogeneous rock using discrete element model based on digital image processing. Rock Mechanics and Rock Engineering, 49(12), 4957–4964.
Walton, G., Alejano, L. R., Arzua, J., & Markley, T. (2018). Crack damage parameters and dilatancy of artificially jointed granite samples under triaxial compression. Rock Mechanics and Rock Engineering, 51(6), 1637–1656.
Wang, C. X., Shen, B. T., Chen, J. T., Tong, W. X., Zhe, J., Liu, Y., et al. (2020). Compression characteristics of filling gangue and simulation of mining with gangue backfilling: An experimental investigation. Geomechanics and Engineering, 20(6), 485–495.
Wu, Q., Wang, J. H., Liu, D. H., Cui, F. P., & Liu, S. Q. (2009). A new practical methodology of the coal floor water bursting evaluating IV: The application of AHP vulnerable index method based on GIS. Journal of China Coal Society, 34(2), 233–238.
Wu, Q., Zhang, B., Zhao, W. D., & Liu, S. Q. (2013). A new practical methodology of coal seam floor water burst evaluation: The comparison study among ANN, the weight of evidence and the logistic regression vulnerable index method based on GIS. Journal of China Coal Society, 38(1), 21–26.
Xu, Z. L. (2016). Elasticity. Beijing: High Education Press.
Yin, L. M., & Chen, J. T. (2013). Experimental study of influence of seepage pressure on joint stress–seepage coupling characteristics. Rock and Soil Mechanics, 34(9), 2563–2568.
Yin, L. M., Guo, W. J., & Chen, J. T. (2014). Development of true triaxial rock test system of coupled stress-seepage and its application. Chinese Journal of Rock Mechanics and Engineering, 33(S1), 2820–2826.
Zhao, J., Bo, L., Juntao, C., & Jiang, N. (2020a). Mechanism of seepage-stress fault water inrush and grouting seal. Arabian Journal of Geoscience. https://doi.org/10.1007/s12517-020-05319-5.
Zhao, J., Chen, J., Zhang, X., et al. (2020b). Distribution characteristics of floor pore water pressure based on similarity simulation experiments. Bulletin of Engineering Geology and the Environment. https://doi.org/10.1007/s10064-020-01835-6.
Zhao, X. L., Huang, B. X., & Wang, Z. (2018a). Experimental investigation on the basic law of directional hydraulic fracturing controlled by dense linear multi-hole drilling. Rock Mechanics and Rock Engineering, 51(6), 1739–1754.
Zhao, J., Yin, L., & Guo, W. (2018b). Stress–seepage coupling of cataclastic rock masses based on digital image technologies. Rock Mechanics and Rock Engineering, 51(8), 2355–2372. https://doi.org/10.1007/s00603-018-1474-5.
Zhao, J., Zhang, X., Jiang, N., et al. (2020c). Porosity zoning characteristics of fault floor under fluid–solid coupling. Bulletin of Engineering Geology and the Environment, 79(5), 2529–2541. https://doi.org/10.1007/s10064-019-01701-0.
Zhao, Q. B., Zhao, X. N., Wu, Q., Liu, C. W., & Wang, X. L. (2015). Water burst mechanism of “divided period and section burst” at deep coal seam floor in North China type coalfield mining area. Journal of China Coal Society, 40(7), 1601–1607.
Zhou, Q. L., & Liu, G. F. (1982). Compression-shear fracture of brittle materials. Journal of Hydraulic Engineering Division of the American Society of Civil Engineers, 7, 63–69.
Acknowledgements
This research was supported by the National Natural Science Foundation of China (Grant nos. 51974172, 51874192), the China Postdoctoral Science Foundation (Grant no. 2016M601171), the Natural Science Foundation of Shandong Province (ZR2019MEE004), the “Youth Innovation and Technology Plan” of Shandong colleges and Universities (2020KJH001), and the State Key Laboratory of Mining Disaster Prevention and Control Co-founded by Shandong Province and the Ministry of Science and Technology of China (Grant no. MDPC2016ZR01). We also thank LetPub for the linguistic assistance during the preparation of this manuscript. This study was funded by Innovative Research Group Project of the National Natural Science Foundation of China (51604167), the Key Research and Development Program of Shandong Province, China (2018GSF117018).
Author information
Authors and Affiliations
Corresponding authors
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Chen, J., Zhao, J., Zhang, S. et al. An Experimental and Analytical Research on the Evolution of Mining Cracks in Deep Floor Rock Mass. Pure Appl. Geophys. 177, 5325–5348 (2020). https://doi.org/10.1007/s00024-020-02550-9
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00024-020-02550-9