Abstract
The mechanical properties of triaxially braided composites under transverse loads are found to be size-dependent, due to the presence of free-edge effect. Numerical studies of the mechanical behaviors of straight-sided coupon specimens and an infinitely large plate under both axial and transverse tension loads were conducted using a meso-scale finite element model. The numerical model correlates well with experimental results, successfully capturing the free-edge warping phenomena under transverse tension. Free-edge effect is observed as out-of-plane warping, and it can be correlated to the premature damage initiation in the affected area. The numerical results characterize the impact of free-edge effects on the global stress–strain response and local failure mechanisms. By conducting dimensional analysis, the relationships of effective stiffness and strength against specimen width are quantified using Weibull equations. The results of this study indicate that the free-edge effect is an inherent behavior of braided architecture. The free-edge effect produces significantly reduced transverse tension modulus and strength measurements.
Similar content being viewed by others
References
Zweben, C.: Designer’s corner: Is there a size effect in composites? Composites 25, 451–454 (1994)
Wagner, H.D.: Statistical concepts in the study of fracture properties of fibres and composites. In: Friedrich, K. (ed.) Application of Fracture Mechanics to Composite Materials, pp. 39–77. Elsevier, North-Holland (1989)
Wisnom, M., Atkinson, J., Jones, M.: Reduction in compressive strain to failure with increasing specimen size in pin-ended buckling tests. Compos. Sci. Technol. 57, 1303–1308 (1997)
Wisnom, M.R.: Size effects in tensile, compressive and interlaminar failure of unidirectional composites. In: Simitses, G.J. (ed.) Analysis and Design Issues for Modern Aerospace Vehicles- 1997, pp. 67–77. American Society of Mechanical, New York (1997)
Bullock, R.: Strength ratios of composite materials in flexure and in tension. J. Compos. Mater. 8, 200–206 (1974)
Camponeschi, E., Gillespie, J., Wilkins, D.: Kink-band failure analysis of thick composites in compression. J. Compos. Mater. 27, 471–490 (1993)
Wisnom, M.R.: The effect of specimen size on the bending strength of unidirectional carbon fibre-epoxy. Compos. Struct. 18, 47–63 (1991)
Wisnom, M.: Size effects in the testing of fibre-composite materials. Compos. Sci. Technol. 59, 1937–1957 (1999)
O’Brien, T.K.: Characterization of delamination onset and growth in a composite laminate. In: Reifsnider, K.L. (ed.) Damage in Composite Materials, ASTM STP775, pp. 140–167. American Society for Testing and Materials, Ann Arbor, MI (1982)
Daniel, I., Whitney, J., Pipes, R.: Experimental mechanics of fiber reinforced composite materials. Exp. Tech. 7, 25 (1983)
Herakovich, C.T.: Influence of layer thickness on the strength of angle-ply laminates. J. Compos. Mater. 16, 216–227 (1982)
Mittelstedt, C., Becker, W.: Interlaminar stress concentrations in layered structures: Part I-a selective literature survey on the free-edge effect since 1967. J. Compos. Mater. 38, 1037–1062 (2004)
Sun, C., Zhou, S.: Failure of quasi-isotropic composite laminates with free-edges. J. Reinf. Plast. Compos. 7, 515–557 (1988)
Pipes, R.B., Pagano, N.J.: Interlaminar stresses in composite laminates under uniform axial extension. J. Compos. Mater. 4, 538–548 (1970)
Rose, C.A., Herakovich, C.T.: An approximate solution for interlaminar stresses in composite laminates. Compos. Eng. 3, 271–285 (1993)
Tahani, M., Nosier, A.: Free-edge stress analysis of general cross-ply composite laminates under extension and thermal loading. Compos. Struct. 60, 91–103 (2003)
Bar-Yoseph, P., Ben-David, D.: Free-edge effects in unsymmetrically laminated composite plates. Compos. Struct. 30, 13–23 (1995)
Bauld, N.R., Goree, J.G., Tzeng, L.S.: A comparison of finite-difference and finite-element methods for calculating free-edge stresses in composites. Comput. Struct. 20, 897–914 (1985)
Pipes, R.B.: Boundary layer effects in composite laminates. Fibre Sci. Technol. 13, 49–71 (1980)
Esquej, R., Castejon, L., Lizaranzu, M., Carrera, M., Miravete, A., Miralbes, R.: A new finite element approach applied to the free-edge effect on composite materials. Compos. Struct. 98, 121–129 (2013)
Berbinau, P., Wolff, E.G.: Analytical model for prediction of microbuckling initiation in composite laminates. In: Scott, M.L. (ed.) Proceeding of 11th International Conference on Composite Material, pp. 807–817. Gold Coast, Queensland Australia (1997)
Littell, J.D., Binienda, W.K., Roberts, G.D., Goldberg, R.K.: Characterization of damage in triaxial braided composites under tensile loading. J. Aerosp. Eng. 22, 270–279 (2009)
Kohlman, L.W.: Evaluation of Test Methods for Triaxial Braid Composites and the Development of a Large Multiaxial Test Frame for Validation Using Braided Tube Specimens. The University of Akron, Akron (2012)
Macander, A.B., Crane, R.M., Camponeschi, E.T.: Fabrication and mechanical properties of multidimensionally (XD) braided composite materials. In: Whitney, J.M. (ed.) Composite Materials Testing and Design, ASTM STP893, pp. 422–445. American Society for Testing and Materials, Philadelphia, PA (1986)
Pickett, A.K., Fouinneteau, M.: Material characterisation and calibration of a meso-mechanical damage model for braid reinforced composites. Compos. Part A 37, 368–377 (2007)
Kohlman, L.W., Bail, J.L., Roberts, G.D., Salem, J.A., Martin, R.E., Binienda, W.K.: A notched coupon approach for tensile testing of braided composites. Compos. Part A 43, 1680–1688 (2012)
Zhang, C., Binienda, W.K., Kohlman, L.W., Goldberg, R.K.: Meso-scale failure modeling of single layer triaxially braided composite using finite element method. Compos. Part A 58, 36–46 (2014)
Li, X., Binienda, W.K., Goldberg, R.K.: Finite-element model for failure study of two-dimensional triaxially braided composite. J. Aerosp. Eng. 24, 170–180 (2010)
Hashin, Z., Rotem, A.: A fatigue failure criterion for fiber reinforced materials. J. Compos. Mater. 7, 448–464 (1973)
Simulia Dassault Systems Corporation: Abaqus 6.11 Documentation, Providence (2011)
Zhang, C., Binienda, W.K., Kohlman, L.W.: Analytical and numerical analysis on elastic behavior of triaxial braided composites. J. Aerosp. Eng. (2013). doi:10.1061/(ASCE)AS.1943-5525.0000369
Kueh, A.B.H.: Size-influenced mechanical isotropy of singly-plied triaxially woven fabric composites. Compos. Part A 57, 76–87 (2014)
Cater, C.R., Xiao, X., Goldberg, R.K., Kohlman, L.W.: Improved subcell model for the prediction of braided composite response. In: Proceeding of 54th AIAA/ASME/ASCE/AHS/ASC Structures, structure dynamics and materials conference, pp. 1628. American Institute of Aeronautics and Astronautics, Boston, Massachusetts (2013)
Bazant, Z.P., Chen, E.P.: Scaling of structural failure. Appl. Mech. Rev. 50, 593–627 (1997)
Weibull, W.: A statistical distribution function of wide applicability. J. Appl. Mech. 18, 293–297 (1951)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Zhang, C., Binienda, W.K. Numerical Analysis of Free-Edge Effect on Size-Influenced Mechanical Properties of Single-Layer Triaxially Braided Composites. Appl Compos Mater 21, 841–859 (2014). https://doi.org/10.1007/s10443-014-9386-3
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10443-014-9386-3