Abstract
Purpose
This study compares transport performance of residual biomass using different pre-treatment options. Life cycle inventory data was obtained from forestry companies in southern Chile, databases, scientific and technological literature, as well as equipment operational manuals.
Methods
Three different scenarios were evaluated: residual biomass transport without pre-treatment (scenario 1), chipped residual biomass (scenario 2), and compacted residual biomass (scenario 3) transport. The truck’s loading capacity was considered as a function of the residual biomass density. Impact assessment was performed using software SimaPro 7.3.3 using the ReCiPe midpoint methodology. Moreover, an uncertainty analysis was performed using Monte Carlo simulation with a 95 % confidence. Transport costs evaluation variables considered were machine cost, machine residual value, amortization, personnel costs, fuel consumption, machine maintenance, and operational yield. All variables are based on local conditions of La Araucanía Region in Chile.
Results and discussion
Regarding greenhouse gas (GHG) emissions, optimum transport distance ranges were identified for the different scenarios. For a distance up to 23 km, scenario 1 is the most favorable; for distances between 23 and 206 km, scenario 2 is the most favorable one; and for distances longer than 206 km, compacted residual biomass (scenario 3) presents the lowest GHG emissions balance. When looking the other impact categories, it was established that the benefits are not only related to GHG emission savings but also to other impact categories. Transport impacts are only relevant for large distances, while for short distances biomass pre-treatment and loading stages provoke a higher environmental load. In fact, for scenario 2 where chipped biomass is transported, only for distances longer than 120 km, the transport stage accounts for more than 50 % of the environmental load of all impact categories. For the case of scenario 3 (compacted biomass transport), this situation occurs for a distance of at least 150 km.
Conclusions
Most probable optimal transport distances were determined for pre-treated and unpretreated biomass. In this sense, for determining the best transport option of residual biomass, transport distance, loading capacity, and pre-treatment processes efficiency, including chipping and compacting, as well as data uncertainty, should be taken into account. From these variables, biomass loading and pre-treatment stages account for a relevant percentage of the environmental impacts generated for transport distances of less than 100 km. In this sense, biomass loading and pre-treatment efficiency coupled with the effective supplies demand should be carefully studied in future research works.
Similar content being viewed by others
References
Beccali G, Cellura M, Mistretta M (2001) Managing municipal solid waste. Energetic and environmental comparison among different management options. Int J Life Cycle Assess 6:243–249
Bergsdal H, Strømman A, Hertwich EG (2005) Environmental assessment of two waste incineration strategies for central Norway. Int J Life Cycle Assess 10:263–272
Bojacá C, Schrevens E (2010) Parameter uncertainty in LCA: stochastic sampling under correlation. Int J Life Cycle Assess 15:238–246
Braam J, Tanner T, Askham C, Hendriks N, Maurice B, Mälkki H, Vold M, Wessman H, Beaufort A (2001) Energy, transport and waste models—availability and quality of energy, transport and waste models and data. Int J Life Cycle Assess 6(3):135–139
Bruno C, Castiglioni F, Girando C, Ferrero R, Ragazzoni C (2002) LCA of alternative scenarios for WMS in Cuneo province (in Italian: ‘LCA di scenari alternativi per la gestione integrata di RSU nel bacino 10 della Provincia di Cuneo’). Università degli Studi di Milano Bicocca, Dipartimento di Scienze dell'Ambiente e del Territorio (in Italian)
CNE (2008) Potencial de biomasa forestal. Comisión Nacional de Energía. Santiago, Chile. http://antiguo.cne.cl/cnewww/export/sites/default/05_Public_Estudios/descargas/Estudio_Potencial_Biomasa_Forestal.pdf
CNE (2011) Generación bruta SING - SIC. Comisión Nacional de Energía, Santiago, Chile
Consoli F (1993) Guidelines for life cycle assessment: a code of practice. SETAC, Sesimbra, Portugal
Cooper J, Woods L, Lee S (2008) Distance and backhaul in commodity transport modelling. Int J Life Cycle Assess 13:389–400
EMEP/EEA (2009) Emission inventory guidebook 2009. http://www.eea.europa.eu/publications/emep-eea-emission-inventory-guidebook-2009
Eriksson O, Carlsson Reich M, Frostell B, Björklund A, Assefa G, Sundqvist JO, Granath J, Baky A, Thyselius L (2005) Municipal solid waste management from a system perspective. J Clean Prod 13:241–252
Fan KQ, Zhang PF, Pei ZJ (2013) An assessment model for collecting and transporting cellulosic biomass. Renew Energ 50:786–794
Finnveden G (1999) Methodological aspects of life cycle assessment of integrated solid waste management systems. Resour Conserv Recycl 26:173–187
Finnveden G, Johansson J, Lind P, Moberg Å (2005) Life cycle assessment from solid waste—part I: general methodology and results. J Clean Prod 13:213–229
Finnveden G, Björklund A, Moberg A, Ekvall T, Moberg A (2007) Environmental and economic assessment methods for waste management decision-support: possibilities and limitations. Waste Manage Res 25:263–269
Frischknecht R, Jungbluth N (2004) Overview and methodology. Ecoinvent Database v1.1. Swiss Centre for Life Cycle Inventories. Dübendorf, Switzerland, 75pp
Frischknecht R, Jungbluth N, Althaus HJ, Doka G, Heck T, Hellweg S, Hischier R, Nemecek T, Rebitzer G, Spielmann M, Wernet G (2007) Overview and methodology. Ecoinvent report N°1. Swiss Centre for Life Cycle Inventories. Dübendorf, Switzerland
Gallego A, Hospido A, Moreira MT, Feijoo G (2009) Quantification of eutrophic aerial compounds in Galicia (NW Spain): part 1—NH3 inventory. Atmósfera 22(2):141–160
García D, Solé C (2005) Estudio sobre la producción de agua potable mediante biomasa forestal. Ideas Sostenibles 3(12):1–8
Huijbregts MAJ, Norris G, Bretz R, Ciroth A, Maurice B, von Bahr B, Weidema B, de Beaufort ASH (2001) Framework for modelling data uncertainty in life cycle inventories. Int J Life Cycle Assess 6(3):127–132
Huijbregts MAJ, Gilijamse W, Ragas MJ, Reijnders L (2003) Evaluating uncertainty in environmental life-cycle assessment. A case study comparing two insulation options for a Dutch onefamily dwelling. Environ Sci Technol 37(11):2600–2608
INE (2009) Compendio estadístico – 2.2 Estadísticas agropecuarias. Instituto Nacional de Estadística. Santiago, Chile. http://www.ine.cl/canales/menu/publicaciones/compendio_estadistico/compendio_estadistico2009.php
ISO 14040 (2006) Environmental management—life cycle assessment—principles and framework. International Organization for Standardization. Geneva, Switzerland
Karlhager J (2008) The Swedish market for wood briquettes—production and market development. ISSN 1654-1367
Miño E (2006) Catastro de residuos biomásicos de la IX Región como recursos para uso energético. Trabajo de Título de Ingeniería Ambiental, Universidad de La Frontera. Temuco, Chile
Morey RV, Kaliyan N, Tiffany DG, Schmidt DR (2010) A corn stover supply logistics system. Appl Eng Agric 26(3):455–461
Muñoz E, Navia R (2011) Life cycle assessment of solid waste management strategies in a chlor-alkali production facility. Waste Manage Res 29(6):634–643
Muñoz I, Rieradevall J, Doménech X, Milà L (2004) LCA application to integrated waste management planning in Gipuzkoa (Spain). Int J Life Cycle Assess 9:272–280
Petrolia DR (2008) The economics of harvesting and transporting corn stover for conversion to fuel ethanol: a case study for Minnesota. Biomass Bioenerg 32(7):603–612
Pisoni E, Raccanelli R, Dotelli G, Botta D, Melià P (2009) Accounting for transportation impacts in the environmental assessment of waste management plans. Int J Life Cycle Assess 14:248–256
Roberts K, Gloy B, Joseph S, Scott N, Lehmann J (2010) Life cycle assessment of biochar systems: estimating the energetic, economic, and climate change potential. Environ Sci Technol 44(2):827–833
Royo J, Sebastián F, García-Galindo D, Gómez M, Díaz M (2012) Large-scale analysis of GHG (greenhouse gas) reduction by means of biomass co-firing at country-scale: application to the spanish case. Energy 48:255–267
Saidur R, Abdelaziz EA, Demirbas A, Hossain MS, Mekhilef MS (2011) A review on biomass as a fuel for boilers. Renew Sust Energ Rev 15:2262–2289
Sing J, Panesar BS, Sharma SK (2010) A mathematical model for transporting the biomass to biomass based power plant. Biomass Bioenerg 34:483–488
Sokhansanj S, Kumar A, Turhollow AF (2006) Development and implementation of integrated biomass supply analysis and logistics model (IBSAL). Biomass Bioenergy 30(10):838–847
Spielmann M, Bauer C, Dones R, Tuchschmid M (2007) Transport services. Ecoinvent Report N°14. Swiss Centre for Life Cycle Inventaries, Dübendorf
Suh K, Suh S (2010) Economic and environmental implications of corn stover densification options for biofuel in Minnesota. Trans ASABE 2010(53):1183–1192
Sultana S, Kumar A (2011) Development of energy and emission parameters for densified form of lignocellulosic biomass. Energy 36:2716–2732
Tchobanogluous G, Theisen H, Vigil S (1994) Gestión integral de residuos sólidos. McGraw-Hill, España
Acknowledgements
The authors thank the financial support of the Chilean FONDEF Project D07I1096.
Author information
Authors and Affiliations
Corresponding author
Additional information
Responsible editor: Nydia Suppen-Reynaga
Rights and permissions
About this article
Cite this article
Muñoz, E., Vargas, S. & Navia, R. Environmental and economic analysis of residual woody biomass transport for energetic use in Chile. Int J Life Cycle Assess 20, 1033–1043 (2015). https://doi.org/10.1007/s11367-015-0891-x
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11367-015-0891-x