Abstract
Intergranular strains due to tensile plastic deformation were investigated in a commercially pure Ti. Neutron diffraction has been used to characterize the evolution of residual elastic strain in grains with different crystallographic orientations. Experimental data have been obtained for the macroscopic stress–strain curve and the intergranular strain evolution in the longitudinal and transverse direction relative to the uniaxial loading axis. The elasto-plastic self-consistent (EPSC) approach was used to model the deformation behavior of the studied material. Comparison between the neutron measurements and the model predictions shows that in most cases the EPSC approach can predict the lattice strain evolution and capture the plastic anisotropy observed in the experiments.
Similar content being viewed by others
References
P.G. Partridge: Int. Mater. Rev., 1967, vol. 12, pp. 169–94.
A.K. Singh, R.A. Schwarzer: Z. Metallkd., 2000, vol. 91, pp. 702–16.
H. Conrad: Prog. Mater. Sci., 1981, vol. 26, pp. 123–403.
S. Zaefferer: Mater. Sci. Eng. A, 2003, vol. 344, pp. 20–30.
M.J. Philippe, M. Serghat, P. Van Houtte, C. Esling: Acta Metall. Mater., 1995, vol. 43, pp. 1619–30.
H. Numakura, Y. Minonishi, M. Koiwa: Scripta Metall., 1986, vol. 20, pp. 1581–86.
M.G. Glavicic, A.A. Salemn, S.L. Semiatin: Acta Mater., 2004, vol. 52, pp. 647–655.
A. Akhtar: Metall. Trans. A, 1975, vol. 6, pp. 1105–113.
D.R. Chichili, K.T. Ramesh, K.J. Hemker: Acta Mater. 1998, vol. 46, pp. 1025–43.
A.A. Salem, S.R. Kalidindi, R.D. Doherty: Acta. Mater., 2003, vol. 51, pp. 4225–37.
R. Levy-Tubiana, A. Baczmanski, A. Lodini: Mater. Sci. Eng. A, 2003, vol. 341, pp. 74–86.
B. Clausen, T. Lorentzen, A.M. Bourke, M.R. Daymond: Mater. Sci. Eng. A, 1999, 199, vol. 259, pp. 17–24.
D. Gloaguen, T. Berchi, E. Girard, R. Guillén: Acta Mater., 2007, vol. 55, pp. 4369–79.
J.L.W. Warwick, N.G. Jones, K.M. Rahman, D. Dye: Acta Mater., 2012, vol. 60, pp. 6720–31.
F. Xu, R.A. Holt, M.R. Daymond: Acta Mater., 2008, vol. 56, pp. 3672–3687.
N. Benmhenni, S. Bouvier, R. Brenner, T. Chauveau, B. Bacroix: Mater. Sci. Eng. A, 2013, vol. 573, pp. 222–23.
N.P. Gurao, R. Kapoor, S. Suwas: Acta Mater., 2011, vol. 59, pp. 3431–46.
B.S. Fromm, B.L. Adams, S. Ahmadi, M. Knezevic: Acta Mater. 2009, vol. 57, pp. 2339–48.
X. Wu, S.R. Kalidindi, C. Necker, A.A. Salem: Acta Mater., 2007, vol. 55, pp. 423–32.
M. Bataini: PhD Dissertation, Monash University, Australia, 2008.
C. Larsson, B. Clausen, T.M. Holden, M.A.M. Bourke: Scripta Mater., 2007, vol. 51, pp. 571–75
C.J. Neil, J.A. Wollmershauser, B. Clausen, C.N. Tomé, S.R. Agnew: Int J Plasticity, 2010, vol. 26, pp. 1772–91.
J.W.L. Pang, T.M. Holden, T.E. Mason: Acta Mater., 1998, vol. 46, pp. 1503–18.
P. Dawson, D. Boyce, S. macEwen, R. Rogge: Mater. Sci. Eng. A, 2001, vol. 313, pp. 123–44
A. Baczmanski, N. Hfaiedh, M. François, K. Wierzbanowki: Mater Sci Eng A, 2009, vol. 501, pp. 153–65.
H. Wang, P.D. Wu, C.N. Tomé, J. Wang: Int. J. Solids Struct., 2012, vol. 26, pp. 1772–91.
O. Muransky, M.R. Barnett, V. Luzin, Vogel: Mater. Sci. Eng. A., 2010, vol. 527, pp. 1383–94.
J.W.L. Pang, T.M. Holden, P.A. Turner, T.E. Mason: Acta Mater., 1999, vol. 47, pp. 373–83.
P. Rangaswamy, A.M. Bourke, D.W. Brown, G.C. Kaschner, RB Rogge, MG Stout, CN Tomé: Metall. Trans. A, 2002, vol. 33, pp. 757–63.
D. Gloaguen, M. François, R. Guillen, J. Royer: Phys. Status Solidi a, 2002, vol. 193, pp. 12–25.
J.R. Cho, D. Dye, K.T. Conlon, M.R. Daymond, R.C. Reed: Acta Mater., 2002, vol. 50, pp. 4847–64.
J.L.W. Warwick, J. Coakley, S.L. Raghunathan, R.J. Talling, D. Dye: Acta Mater., 2012, vol. 60, pp. 4117–27.
S.L. Raghunathan, A.M. Stapleton, R.J. Dashwood, M. Jackson, D. Dye: Acta Mater., 2007, vol. 55, pp. 6861–72.
D. Gloaguen, G. Oum, V. Legrand, J. Fajoui, S. Branchu: Acta Mater., 2013, vol. 61, pp. 5779–5790.
W. Kockelmann, L.C. Chapon, P.G. Radelli: Physica B, 2006, vol. 385, pp. 639–43.
Hannon AC (2005), Nucl Instrum Methods Phys Res 551: 88-107.
Wenk HR, Matthies S, Donavan J, Chateigner D (1998), J Appl Cryst 31:262-269.
Pirling T, Bruno G, Withers PJ (2006), Mater Sci Eng A 437:139-144.
Richard D, Ferrand M, Kearley GJ (1996, J Neutron Res 4:33-39.
Kröner E (1961, Acta Metall 9:155-161.
Hill R (1965), J Mech Phys Solids 13: 89-101.
Gloaguen D, Berchi T, Girard E, Guillén R (2008), J Nucl Mater 374:138-146.
Lipinski P, Berveiller M (1989), Int J Plasticity 5:149-172.
Hutchinson W (1970), Proc R Soc London A 319:247-272.
Simmons G, Wang H (1971) Single crystal elastic constants and calculated aggregate properties, Cambridge MA, M.I.T. Press.
Dye D, Stone H J, Reed R C (2001), Curr. Opin. Solid State Mater. Sci. 5: 31-37.
Muransky O, Carr DG, Barnett MR, Oliver EC, Sittner P (2008), Mater Sci Eng A 496: 14-24.
Acknowledgments
The authors thank the ISIS and ILL neutron facilities scientific committees for the allocated experimental days on the SALSA (experiment 1-02-30, ILL, France) and GEM (experiment RB1010055, ISIS, UK) instruments.
Author information
Authors and Affiliations
Corresponding author
Additional information
Manuscript submitted October 7, 2014.
Rights and permissions
About this article
Cite this article
Gloaguen, D., Oum, G., Legrand, V. et al. Intergranular Strain Evolution in Titanium During Tensile Loading: Neutron Diffraction and Polycrystalline Model. Metall Mater Trans A 46, 5038–5046 (2015). https://doi.org/10.1007/s11661-015-3073-3
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11661-015-3073-3