Abstract
The bearing capacity calculations for nonhomogeneous and anisotropic clay foundation are often employed the methods of limit equilibrium, limit analysis and characteristic. In this paper, an approach of upper bound theorem in conjunction with new failure mechanism is adopted to estimate the bearing capacity of foundation in nonhomogeneous and anisotropic clays. The proposed failure mechanism is composed of a series of rigid blocks, which is constructed in a manner to respect the normality condition of limit analysis theory at every point of velocity discontinuity surfaces, considering the property of spatially varying materials. Using a spatial discretization technique, the slip surface of failure mechanism is determined point by point. Based on upper bound theory of limit analysis, the internal energy dissipation and the work rate of external forces are calculated for each block. Coding the corresponding computer program, the solutions of bearing capacity of nonhomogeneous and anisotropic clay foundation are obtained. The results are compared with those previously published solutions using the characteristic and limit equilibrium methods. From the comparisons, it is found that the approach of this paper is effective to analyze the bearing capacity of nonhomogeneous and anisotropic clays. Then, the solutions are presented, and the influence of nonhomogeneity and anisotropy on the bearing capacity is discussed.
Similar content being viewed by others
References
Al-Shamrani, M. A. (2005). “Upper-bound solutions for bearing capacity of strip footings over anisotropic nonhomogeneous clays.” Soils and Foundations, Vol. 45, No. 1, pp. 109–124. DOI: 10.1061/9780784412121.110.
Al-Shamrani, M. A. and Moghal, A. A. B. (2012). “Upper bound solutions for bearing capacity of footings on anisotropic cohesive soils.” C. GeoCongress State of the Art and Practice in Geotechnical Engineering, ASCE, pp. 1066–1075.
Chen, W. F. (1975). “Limit analysis and soil plasticity.” Elsevier, Amsterdam.
Casagrande, A. and Carillo, N. (1944). “Shear failure of anisotropic materials.” Journal of Boston Society of Civil Engineers, Vol. 31, No. 4, pp. 74–81.
Davis, E. H. and Booker, J. R. (1973). “The effect of increasing strength with depth on the bearing capacity of clays.” Geotechnique, Vol. 23, No. 4, pp. 551–563, DOI: 10.1680/geot.1973.23.4.551.
Davis, E. H. and Christian, J. T. (1971). “Bearing capacity of anisotropic cohesive soil.” Journal of the Soil Mechanics and Foundations Division, Vol. 97, No. 5, pp. 753–769.
Gourvenec, S. and Randolph, M. (2003). “Effect of strength nonhomogeneous on the shape of failure envelopes for combined loading of strip and circular foundations on clay.” Geotechnique, Vol. 53, No. 6, pp. 575–586, DOI: 10.1680/geot.2003.53.6.575.
Livneh, M. and Greenstein, J. (1972). “The bearing capacity of footings on nonhomogeneous clays.” Bruner Institute of Transportation, Technion Research and Development Foundation Limited.
Lo, K. Y. (1965). “Stability of slopes in anisotropic soils.” J. Journal of the Soil Mechanics and Foundations Division, ASCE, Vol. 91, No. 4, pp. 85–106.
Michalowski, R. L. (2002). “Collapse loads over two-layer foundation soils.” Soils and Foundations, Vol. 42, No. 1, pp. 1–7, DOI: 10.3208/sandf.42.1.
Mollon, G., Phoon, K. K., Dias, D., and Soubra, A. H. (2010). “Validation of a new 2D failure mechanism for the stability analysis of a pressurized tunnel face in a spatially varying sand.” Journal of Engineering Mechanics, Vol. 137, No.1, pp. 8–21, DOI: 10.1061/(ASCE)EM.1943-7889.0000196.
Pan, Q. J. (2014). “Kinematical analysis of the face stability for a shielddriven tunnel.” Central South University, Changsha.
Peck, R. B., Hanson, W. E., and Thornburn, T. H. (1953). “Foundation engineering.” 2nd ed. New York: John Wiley and Sons.
Reddy, A. S. and Rao, K. N. (1981). “Bearing capacity of strip footing on anisotropic and nonhomogeneous clays.” Soils and Foundations, Vol. 21, No. 1, pp. 1–6, DOI: 10.3208/sandf1972.21.1.
Reddy, A. S. and Srinivasan, R. J. (1970). “Bearing capacity of footings on anisotropic soils.” Journal of the Soil Mechanics and Foundations Division, ASCE, Vol. 96, No. 6, pp. 1967–1986, DOI: 10.3208/sandf1960.11.3_51.
Skempton, A. W. (1951). “The bearing capacity of clays.” Proceedings of the Building Research Congress, London, pp. 180–189.
Yang, X. L. and Yan, R. M. (2015). “Collapse mechanism for deep tunnel subjected to seepage force in layered soils.” Geomechanics and Engineering, Vol. 8, No. 5, pp. 741–756, DOI: 10.12989/gae.2015.8.5.741.
Yang, X. L. and Pan, Q. J. (2015). “Three dimensional seismic and static stability of rock slopes.” Geomechanics and Engineering, Vol. 8, No. 1, pp. 97–111, DOI: 10.12989/gae.2015.8.1.097.
Yang, X. L., Li, W. T., and Pan, Q. J. (2015). “Influences of anisotropy and inhomogeneity on supporting pressure of tunnel face with kinematical approach.” Journal of Central South University, Vol. 22, No. 9, pp. 3536–3543, DOI: 10.1007/s11771-015-2893-z.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Yang, XL., Du, DC. Upper bound analysis for bearing capacity of nonhomogeneous and anisotropic clay foundation. KSCE J Civ Eng 20, 2702–2710 (2016). https://doi.org/10.1007/s12205-016-0087-3
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12205-016-0087-3