Abstract
This paper proposes a novel method for simultaneous estimation of unknown switched external disturbance and precise position control of dynamical systems which employ worm gear drive reducers. This algorithm is based on an improved discrete sliding mode control (DSMC) design which ensures convergence to the desired sliding set without introducing chattering effects to the dynamical system. In order to improve the performance of DSMC and to obtain an accurate estimation of gearbox model, a new method for incorporation of switched friction is proposed in the presence of external disturbance. To this end, the dynamical response of worm gear drive reducer is investigated in distinct switched disturbance modes of resistive disturbances, assistive disturbances and no disturbance to obtain approximate functions describing system dynamics in aforementioned configurations. In comparison with the feedback data, the obtained models permit appropriate incorporation of friction into the improved DSMC scheme. Based on multiple common Lyapunov functions and calculation of virtual reference signals for armature currents, the feasibility of control algorithm is ensured in all modes of switched dynamics. The effectiveness of the proposed estimation and control schemes has been verified using an experimental setup employing a worm gear drive reducer on which multiple permanent magnet DC motors are installed, and improvements resulted from incorporation of friction estimation algorithm are analyzed.
Similar content being viewed by others
References
Abed, W., Sharma, S., Sutton, R., & Motwani, A. (2015). A robust bearing fault detection and diagnosis technique for brushless DC motors under non-stationary operating conditions. Journal of Control, Automation and Electrical Systems,26(3), 241–254. https://doi.org/10.1007/s40313-015-0173-7.
Björling, M., Miettinen, J., Marklund, P., Lehtovaara, A., & Larsson, R. (2015). The correlation between gear contact friction and ball on disc friction measurements. Tribology International,83, 114–119. https://doi.org/10.1016/j.triboint.2014.11.007.
Cao, W., Pu, W., Wang, J., & Xiao, K. (2018). Effect of contact path on the mixed lubrication performance, friction and contact fatigue in spiral bevel gears. Tribology International,123, 359–371. https://doi.org/10.1016/j.triboint.2018.03.015.
Childs, P. R. N. (2014). Worm gears. Mechanical design engineering handbook. Burlington: Butterworth-Heinemann. https://doi.org/10.1016/B978-0-08-097759-1.00011-3.
Crosher, W. P. (2002). Design and application of the worm gear. Design and application of the worm gear. New York: ASME Press. https://doi.org/10.1289/ehp.1408412.
Diez-Ibarbia, A., Fernandez-del-Rincon, A., de-Juan, A., Iglesias, M., Garcia, P., & Viadero, F. (2018). Frictional power losses on spur gears with tip reliefs. The friction coefficient role. Mechanism and Machine Theory,121, 15–27. https://doi.org/10.1016/j.mechmachtheory.2017.10.003.
Du, H., Chen, X., Wen, G., Yu, X., & Lu, J. (2018). Discrete-time fast terminal sliding mode control for permanent magnet linear motor. IEEE Transactions on Industrial Electronics,65(12), 9916–9927. https://doi.org/10.1109/TIE.2018.2815942.
Dudás, I. (2017). The theory & practice of worm gear drives. London: Penton Press.
Fernandez-Del-Rincon, A., Diez-Ibarbia, A., & Theodossiades, S. (2019). Gear transmission rattle: Assessment of meshing forces under hydrodynamic lubrication. Applied Acoustics,144, 85–95. https://doi.org/10.1016/j.apacoust.2017.04.001.
Hairer, E., Wanner, Gerhard, & Nørsett, Syvert P. (1993). Solving ordinary differential equations I: Nonstiff problems. Berlin: Springer.
Hammami, M., Martins, R., Fernandes, C., Seabra, J., Abbes, M. S., & Haddar, M. (2018). Friction torque in rolling bearings lubricated with axle gear oils. Tribology International,119, 419–435. https://doi.org/10.1016/j.triboint.2017.11.018.
Han, S. I., & Lee, J. (2016). Finite-time sliding surface constrained control for a robot manipulator with an unknown deadzone and disturbance. ISA Transactions,65, 307–318. https://doi.org/10.1016/j.isatra.2016.07.013.
He, S., & Singh, R. (2008). Dynamic transmission error prediction of helical gear pair under sliding friction using Floquet theory. Journal of Mechanical Design,130(5), 052603. https://doi.org/10.1115/1.2890115.
Homaeinezhad, Mohammad Reza, Tahbaz-zadeh Moghaddam, I., Khakpour, Z., & Naseri, H. (2015). Short-time linear quadratic form technique for estimating fast-varying parameters in feedback loops. Asian Journal of Control,17(6), 2289–2302. https://doi.org/10.1002/asjc.1141.
Homaeinezhad, M. R., & Yaqubi, S. (2019). Discrete-time sliding-surface based control of parametrically uncertain nonlinear systems with unknown time-delay and inaccessible switching mode detection. International Journal of Control. https://doi.org/10.1080/00207179.2019.1605205.
Homaeinezhad, M. R., Yaqubi, S., & Fotoohinia, F. (2019). FEA based discrete-time sliding mode control of uncertain continuum mechanics MIMO vibrational systems. Journal of Sound and Vibration,460, 114902. https://doi.org/10.1016/j.jsv.2019.114902.
Homaeinezhad, M. R., Yaqubi, S., & Gholyan, H. M. (2020). Control of MIMO mechanical systems interacting with actuators through viscoelastic linkages. Mechanism and Machine Theory,147, 103763. https://doi.org/10.1016/j.mechmachtheory.2019.103763.
Huber, O., Acary, V., & Brogliato, B. (2016). Lyapunov stability and performance analysis of the implicit discrete sliding mode control. IEEE Transactions on Automatic Control,61(10), 3016–3030. https://doi.org/10.1109/TAC.2015.2506991.
Kolekar, A. S., Olver, A. V., Sworski, A. E., & Lockwood, F. E. (2013). The efficiency of a hypoid axle-a thermally coupled lubrication model. Tribology International,59, 203–209. https://doi.org/10.1016/j.triboint.2012.03.013.
Li, M., Yang, K., Zhu, Y., Mu, H., & Hu, C. (2017). State/model-free variable-gain discrete sliding mode control for an ultraprecision wafer stage. IEEE Transactions on Industrial Electronics,64(8), 6695–6705. https://doi.org/10.1109/TIE.2016.2645893.
Liang, Y., Cong, S., & Shang, W. (2008). Function approximation-based sliding mode adaptive control. Nonlinear Dynamics,54(3), 223–230. https://doi.org/10.1007/s11071-007-9324-0.
Matsuda, H., & Takahashi, M. (2017). Periodic disturbance rejection control based on observer and switching in photo-conductor drum with planetary gear system. IFAC-PapersOnLine,50(1), 6022–6028. https://doi.org/10.1016/j.ifacol.2017.08.1441.
Rashidi, B., Esmaeilpour, M., & Homaeinezhad, M. R. (2015). Precise angular speed control of permanent magnet DC motors in presence of high modeling uncertainties via sliding mode observer-based model reference adaptive algorithm. Mechatronics,28, 79–95. https://doi.org/10.1016/j.mechatronics.2015.04.009.
Ruzek, M., Ville, F., Velex, P., Boni, J. B., & Marchesse, Y. (2019). On windage losses in high-speed pinion-gear pairs. Mechanism and Machine Theory,132, 123–132. https://doi.org/10.1016/j.mechmachtheory.2018.10.018.
Shi, Z., Zuo, Z., & Liu, H. (2017). Backstepping control for gear transmission servo systems with unknown partially nonsymmetric deadzone nonlinearity. Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science,231(14), 2580–2589. https://doi.org/10.1177/0954406216639343.
Slotine, J., & Li, W. (1990). Applied nonlinear control. Englewood Cliffs, NJ: Prentice Hall.
Taheri, B., Sedaghat, M., Bagherpour, M. A., & Farhadi, P. (2019). A new controller for DC-DC converters based on sliding mode control techniques. Journal of Control, Automation and Electrical Systems,30(1), 63–74. https://doi.org/10.1007/s40313-018-00427-w.
Tang, L., & Zhao, J. (2017). Adaptive tracking control for discrete-time switched nonlinear systems with dead-zone inputs. Fuzzy Sets and Systems,344(1), 1–19. https://doi.org/10.1016/j.fss.2017.07.018.
Vaishya, M., & Singh, R. (2003). Strategies for modeling friction in gear dynamics. Journal of Mechanical Design,125(2), 383. https://doi.org/10.1115/1.1564063.
Yeh, T. J., & Wu, F. K. (2005). Modeling and robust control of worm-gear driven systems. Simulation Modelling Practice and Theory,17(5), 767–777. https://doi.org/10.1016/j.simpat.2009.01.002.
Yeh, T. J., & Wu, F. K. (2009). Modeling and robust control of worm-gear driven systems. Simulation Modelling Practice and Theory,17(5), 767–777. https://doi.org/10.1016/j.simpat.2009.01.002.
Zhu, J., Yu, X., Zhang, T., Cao, Z., Yang, Y., & Yi, Y. (2016). Sliding mode control of MIMO Markovian jump systems. Automatica,68, 286–293. https://doi.org/10.1016/j.automatica.2016.01.070.
Zuo, Z., Ju, X., & Ding, Z. (2016). Control of gear transmission servo systems with asymmetric deadzone nonlinearity. IEEE Transactions on Control Systems Technology,24(4), 1472–1479. https://doi.org/10.1109/TCST.2015.2493119.
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Homaeinezhad, M.R., Yaqubi, S. & Dolatabad, M.A. Friction-Tracker-Embedded Discrete Finite-Time Sliding Mode Control Algorithm for Precise Motion Control of Worm-Gear Reducers Under Unknown Switched Assistive/Resistive Loading. J Control Autom Electr Syst 31, 743–759 (2020). https://doi.org/10.1007/s40313-020-00583-y
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s40313-020-00583-y