Abstract
The increasing use of biofuels is a major challenge for combustion engine manufacturers in terms of performance and CO2 efficiency. The cetane number, as it is one of the most important fuel numbers for Diesel fuels, is derived from the ignition delay which represents the period between the beginning of fuel injection and the start of combustion. This ignition delay is evaluated by using a single cylinder test engine and measuring the time difference between the signal of the needle stroke sensor which is mounted directly at the injection valve and the maximum pressure increase in cylinder.
This conventional test method for fossil fuels, however, determines ignition behavior of biofuels only insufficiently. The pressure increase of biofuels at start of combustion is less steep due to their lower reaction kinetics and spray quality and therefore results in inaccuracies concerning the determination of cetane numbers.
The method suggested by the bioFIRe project starts with a pressure pattern analysis in order to receive parameters that provide important conversion points in the combustion process. Thus, the ignition delay of fuels - as currently understood - is reflected correctly. This can be achieved by the calculation of statistically, thermodynamic and reaction kinetic parameters for the combustion and the pressure pattern. This allows to determine the cetane number for biogenic as well as for fossil diesel fuels.
The final aim for a successful introduction of the new determination method for cetane numbers is to proof its reproducibility and accurateness. Besides, this method has to be licensed by the Standards Committee.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Preview
Unable to display preview. Download preview PDF.
References
DIN 51773: Bestimmung der Zündwilligkeit (Cetanzahl) von Dieselkraftstoffen mit dem BASF-Prüfmotor
Lauer, W.: Cetanzahlmessung am Prüfdiesel BASF; Betriebsanleitung, Ausgabe C (1966)
Terschek, R., Gorek, W., Feuerhelm, T.: Die Bestimmung der Cetanzahl – Standpunktpapier des Arbeitskreises 643 im Fachausschuss für Mineralölnormung (FAM), Erschienen in Erdöl Erdgas Kohle, Heft 10 (2008)
Attenberger, A., Remmele, E.: Entwicklung einer Prüfmethode zur Bestimmung der Cetanzahl von Rapsölkraftstoff, Berichte aus dem TFZ 6, Straubing (2003)
Picard, K.: Zielkonflikte im Biokraftstoffmarkt – Konsequenzen für den Verbraucher, MTZ 4-2008, pp. S94–S299 (2008)
Lumpp, B., Rothe, D., Pastötter, C., Lämmermann, R., Jacob, E.: Oxymethylenether als Dieselkraftstoffzusätze der Zukunft; MTZ 3-2011, pp. S198–S202 (2011)
Janssen, A., Jakob, M., Müther, M., Pischinger, S.: Maßgeschneiderte Kraftstoffe aus Biomasse – Potentiale biogener Kraftstoffe zur Emissionsreduktion; MTZ 12-2010, S922–S928 (2010)
Janssen, A., Jakob, M., Schnorbus, T., Kolbeck, A.: Chancen und Herausforderung der Ethanolbeimischung zum Dieselkraftstoff; MTZ 7/8-2011, pp. S572–S577 (2011)
Wichmann, V.: Konzepte und Betriebsstrategien für die Nutzung von Rapsölen in Verbrennungsmotoren für den Einsatz in Landmaschinen, Dissertation, Universität Rostock (2008)
Harndorf, H., Schümann, U., Wichmann, V., Fink, C.: Motorprozessverhalten und Abgasemissionen alternativer Kraftstoffe im Vergleich mit Dieselkraftstoff; MTZ 7/8-2008, pp. S640–S646 (2008)
Harndorf, H., Wichmann, V., Schümann, U., Richter, B.: Requirement specification for the use of biofuels in modern high performance engines. FNR Tagung Neue Biokraftstoffe, Berlin, June 24 (2010)
von Hohenthal, M.-Y.: Zwischen Acker und Labor; MTZ 12-2010, pp. S852–S859 (2010)
The Biofuels Research Advisory Council: Biofuels in the European Union – A vision for 2030 and beyond; Final draft report (2006)
Directive 2003/30/EC of the European Parliament and of the Council (May 8, 2003)
Directive 2009/28/EC of the European Parliament and of the Council (April 23, 2009)
Steinbach, N., Harndorf, H., Weberbauer, F., Thiel, M.: Motorisches Potential von synthetischen Dieselkraftstoffen. MTZ 2-2006, pp. S96–S102 (2006)
Heywood, J.B.: Internal Combustion Engine Fundamentals. Mc Graw Hill (1988) ISBN 0-07-100499-8
Aatola, H., Larmi, M., Sarjovaara, T., Mikkonen, S.: Hydrotreated Vegetable Oil (HVO) as a Renewable Diesel Fuel: Trade-off between NOx, Particulate Emission, and Fuel Consumption of a Heavy Duty Engine; SAE 2008-01-2500
Huber, K.; Hauber, J.: PCT/EP2009/054845; Method for Determining the Ignitability of a Fuel (April 22, 2009)
Author information
Authors and Affiliations
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2012 Springer-Verlag GmbH Berlin Heidelberg
About this paper
Cite this paper
Huber, K., Hauber, J. (2012). Biofire – Biogenic Fuel Ignition Research. In: Subic, A., Wellnitz, J., Leary, M., Koopmans, L. (eds) Sustainable Automotive Technologies 2012. Springer, Berlin, Heidelberg. https://doi.org/10.1007/978-3-642-24145-1_19
Download citation
DOI: https://doi.org/10.1007/978-3-642-24145-1_19
Publisher Name: Springer, Berlin, Heidelberg
Print ISBN: 978-3-642-24144-4
Online ISBN: 978-3-642-24145-1
eBook Packages: EngineeringEngineering (R0)