1. Material-related aspects of the machinability of Austempered Ductile Iron

   • F. Klocke
   • M. Arft
   • D. Lung

   Production Process 07 May 2010 Pages: 433 - 441

   

2. Nondestructive characterization of the surface integrity of cold surface hardened components

   • D. Meyer
   • D. Kruse
   • E. Brinksmeier

   Production Process 05 May 2010 Pages: 443 - 449

   

3. On the limit drawing ratio of magnetron sputtered aluminium–scandium foils within micro deep drawing

   • Frank Vollertsen
   • Zhenyu Hu
   • Bernd Koehler

   Production Process 30 April 2010 Pages: 451 - 456

   

4. Influence of scaled undeformed sections of cut on strain rate, cutting force and temperature

   • B. Denkena
   • L. de Leon
   • J. Köhler

   Production Process 04 May 2010 Pages: 457 - 464

   

5. Optimization of welding parameters for laser bead-on-plate welding using Taguchi method

   • P. Sathiya
   • M. Y. Abdul Jaleel
   • D. Katherasan

   Production Process 04 June 2010 Pages: 465 - 476

   

6. Numerical analysis of the process chain for the production of PM components with integrated information storage

   • Bernd-Arno Behrens
   • Edin Gastan
   • Fabian Lange

   Production Process 22 June 2010 Pages: 477 - 482

   

7. Erratum to: On the reduction of gloss property of organic coated sheet metals after forming

   • H.-D. Pham
   • M. Trompeter
   • A. E. Tekkaya

   Erratum 28 August 2010 Pages: 483 - 489

   

8. Simulation of parallel kinematic machine tools with minimal effort

   • C. Munzinger
   • M. Krauße
   • M. Kipfmüller

   Computer Aided Engineering 30 July 2010 Pages: 491 - 499

   

9. Direct free-form deformation of NC programs for surface reconstruction and form-error compensation

   • Dirk Biermann
   • Alexei Sacharow
   • Tobias Wagner

   Computer Aided Engineering 30 July 2010 Pages: 501 - 507

   

10. Investigation of coated tools’ cutting performance in milling Ti6Al4V and its correlation to the temperature dependent impact resistance of the film

    • F. Klocke
    • N. Michailidis
    • M. Pappa

    Tooling 05 June 2010 Pages: 509 - 514

    

11. Knowledge-based risk evaluation during the offer calculation of customised products

    • Christoph Rimpau
    • Gunther Reinhart

    Production Management 05 June 2010 Pages: 515 - 524

    

12. Structural analysis method for optimized design of complex kinematic structures using static and dynamic models and application to a robotic walking simulator

    • Matthias Brüning
    • Sami Hussein
    • Jörg Krüger

    Machine Tool 03 June 2010 Pages: 525 - 534