The technique of fabrication of polymer–carbon nanotube composite fibers with different types of nanotubes is described. An analysis of the structure of the fibers obtained is carried out. The results of measurements of the electrical and mechanical characteristics of fibers are presented.
Similar content being viewed by others
References
A. V. Eletskii, Carbon nanomaterials, Usp. Fiz. Nauk, 167, No. 9, 25–41 (1997).
É. G. Rakov, Fibers with carbon nanotubes, Ryn. Legk. Prom., No. 48, 10–19 (2007).
B. Vigolo, A. Penicaud, C. Coulon, C. Sauder, R. Pailler, C. Journet, P. Bernier, and P. Poulin, Macroscopic fibers and ribbons of oriented carbon nanotubes, Science, 290, No. 1, 2569–2573 (2000).
É. G. Rakov, Nanotubes and Fullerenes [in Russian], Logos, Minsk (2006).
S. V. Panin, V. E. Panin, B. B. Ovechkin, et al., Scientific principles of the formation of highly strong and wear-resistant polymeric coatings with nanostructured fillers, Fiz. Mezomekh., No. 9, 141–144 (2006).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Inzhenerno-Fizicheskii Zhurnal, Vol. 84, No. 5, pp. 1019–1021, September–October, 2011.
Rights and permissions
About this article
Cite this article
Savchina-Imbro, N.I., Filatov, S.A., Akhremkova, G.S. et al. Composite fibers based on ordered carbon nanotubes and polyvinyl alcohol. J Eng Phys Thermophy 84, 1099–1101 (2011). https://doi.org/10.1007/s10891-011-0571-z
Received:
Revised:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10891-011-0571-z