Abstract
Austenite has been shown to dynamically transform into ferrite during thermomechanical processing . The driving force is the softening that takes place during deformation, while the energy obstacles consist of the free energy difference between austenite and ferrite as well as the shear dilatation and shear accommodation work. Phase transformation can only take place once the driving force is greater than the energy obstacles. In this work, volume fractions of dynamically transformed ferrite from various rolling simulations were presented. The dynamic phase change was verified by performing hot compression experiment using a modified Gleeble system equipped with a synchrotron light X-ray diffraction. The X-ray diffraction measurements were carried out before and during deformation to accurately track the behavior of austenite. The results indicate that austenite indeed transforms dynamically into ferrite. This unusual metallurgical phenomenon is known to generate ultrafine grain microstructure , which translates to improved mechanical properties of steels.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
Ghosh C, Aranas C, Jonas JJ (2016) Dynamic transformation of deformed austenite at temperatures above the Ae3. Prog Mater Sci 82:151–233
Beladi H, Kelly GL, Hodgson PD (2007) Ultrafine grained structure formation in steels using dynamic strain induced transformation processing. Int Mater Rev 52:14–28
Park N, Shibata A, Terada D, Tsuji N (2013) Flow stress analysis for determining the critical condition of dynamic ferrite transformation in 6Ni-0.1C steel. Acta Mater 61:163–173
Chen SC, Huang CY, Wang YT, Yen HW (2017) Mater Des 134(2017):434
Pereloma E, Timokhina I (2018) Deformation-induced phase transformation. Metals 8(11):886
Li CM, Yada H, Yamagata H (1998) A novel observation of strain-induced ferrite-to-austenite retransformation after intercritical deformation of C–Mn steel. Scr Mater 39:963–967
Jonas JJ, Aranas C, Basabe VV, Ghosh C (2014) Dynamic transformation during the torsion simulation of strip rolling. Mater Sci Forum 783:39–44
Basabe VV, Jonas JJ, Ghosh C (2014) Formation of Widmanstätten ferrite in a 0.036% Nb low carbon steel at temperatures above the Ae3. Steel Res Int 85(1):8–15
Aranas C, Jonas JJ (2015) Effect of Mn and Si on the dynamic transformation of austenite above the Ae3 temperature. Acta Mater 82:1–10
Aranas C, Wang T, Jonas JJ (2015) Effect of interpass time on the dynamic transformation of a plain C–Mn and Nb microalloyed steel. ISIJ Int 55(3):647–654
Aranas C, Rodrigues SF, Grewal R, Jonas JJ (2015) Ferrite formation above the Ae3 temperature during the torsion simulation of strip rolling. ISIJ Int 55(11):2426–2434
Zhao L, Park N, Tian Y, Shibata A, Tsuji N (2016) Combination of dynamic transformation and dynamic recrystallization for realizing ultrafine-grained steels with superior mechanical properties. Sci Rep 6:39127
Rodrigues SF, Aranas C, Wang T, Jonas JJ (2017) Dynamic transformation of an X70 steel under plate rolling conditions. ISIJ Int 57(10):162–169
Rodrigues SF, Aranas C, Jonas JJ (2017) Retransformation behavior of dynamically transformed ferrite during the simulated plate rolling of a low C and an X70 Nb steel. ISIJ Int 57(5):929–936
Aranas C, Rodrigues SF, Siciliano F, Jonas JJ (2019) In-situ X-ray diffraction evidence of dynamic transformation of austenite to ferrite during hot compression test in the single austenite phase field. Scripta Mater. submitted
Acknowledgements
The authors thank the National Synchrotron Light Laboratory (LNLS) in Campinas, Brazil, for the access to their facilities for the XRD experiment. The authors also acknowledge with gratitude funding received from the Brazilian National Council for Scientific and Technological Development (CNPq), Research and Support Foundation of Maranhão (FAPEMA), Natural Sciences and Engineering Research Council of Canada (NSERC), New Brunswick Innovation Foundation (NBIF), and Harrison McCain Foundation.
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2020 The Minerals, Metals & Materials Society
About this paper
Cite this paper
Aranas, C., Rodrigues, S., Siciliano, F., Jonas, J.J. (2020). In-Situ X-Ray Diffraction Measurement During Deformation of Austenite Above the Ae3 Temperature. In: TMS 2020 149th Annual Meeting & Exhibition Supplemental Proceedings. The Minerals, Metals & Materials Series. Springer, Cham. https://doi.org/10.1007/978-3-030-36296-6_165
Download citation
DOI: https://doi.org/10.1007/978-3-030-36296-6_165
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-030-36295-9
Online ISBN: 978-3-030-36296-6
eBook Packages: Chemistry and Materials ScienceChemistry and Material Science (R0)